stator

Replaced stator now red reverse light stays on in all forward gears and when neutral light in on 
When put in reverse the light goes out
any ideas how to correct
thanks ahead
 
 

A year or so back bought a used 2003 Polaris Sportsman 700 Twin with a plow for keeping the gravel road around the house snow free-
I've used it for the last year and it works well- have a bit of water in the oil I started a separate thread on.

Are there any "gotcha" on using these things with plows?
I took off the small polaris winch and added a Warn 2500, with synthentic rope so I wasn't getting poked by the wire-
Looking for folks thoughts on these.

I have replaced the cracked stator cover on my non-running 2006 LT-F400F that I purchased recently, checked all the shafts vs the service manual and pics and advice here.  I replaced missing gears, bushings and washers, made sure that truth marks were all aligned properly, that the shift cam springs felt like they returned properly, etc.  IAfter installing the new stator cover I checked the transfer lever for proper movement from L-H-R and then cranked it up.  Happily, it runs and changes gears well in L,  but it will not shift into H or R for anything.  I have opened it back up and am going back through it looking for the missing puzzle piece(s) but how can I best check that I have everything right this time before buttoning it back up?

I just saw a video on TikTok where some guy took the rear end off an ATV and bolted on a roto tiller in place of rear wheels. I wish i saved that video to post here....good thing it was 4 wheel drive...lol but, it seemed to work.
I'm not sure how he made it bolt on to the drive....

Ok guys, I am a glutton for punishment! I picked up this 01 2wd Rancher because the plastics looked good on the marketplace. It has been sitting in the guys back yard for 10 years. The original engine blew and they swapped in an electric shift 4x4 engine. 😒The engine is locked up and was full of water. The wiring is hacked where they tried to get it to run and the rear end needs new swingarm bearings where they left it laying on the ground in the woods for 10 years. Has anyone here ever did the engine swap? First thing is to straighten out the wiring and get the engine free to see if I can get it to crank over. I have swingarm bearings ordered and a new ignition switch. So hopefully I can at least roll it around soon. 🤣