2007 Arctic Cat 700 EFI 4x4 Wiring Diagram

Wiring diagram for 2007 Arctic Cat 700 EFI 4x4

Thanks for posting this!

Wiring diagram for 2007 Arctic Cat 700 EFI 4x4

do you suppose the wiring diagram for a 2008 is the same as 2007?

Here is the diagram for the 2008 model, its probably the same.

Mike

2008 700 EFI Wiring diagram.pdf

need help got 2008 700 4x4 two problems 1 the dash keeps flashing volts put in a new battery still got the problem and 2 the steering when i take off it pulls hard to the left can any bodytell me what might be the problem with these problems

thanks

i have read that if you disconnect the multipin to the pod display, clean it, and dielectric grease it, that may solve it.

if you can raise the rear of the bike, rotate the wheels separately, if you dont have resistance on the left one, you might have an axle/cv joint problem ...

hopefully an A/C guy will jump in ...

you need to check the connector from your stator. they are very prone to failure! the connector melts and causes a short. this connector is of poor design. as for the pulling to the side your caliper may be seizing or a very bad wheel bearing. i dont know the history of your machine so its hard to tell

also you need to check battery voltage (at the battery)when your machine is running. should be 13.8-14.2volts constantly even when rpms are increased.

Thanks. Just got the machine put a new battery in it the old one wouldn't hold a charge