Quantcast
Jump to content

Recommended Posts

Posted (edited)

I have a 1998 arctic cat 454 4x4 that will not at times rev high, cleaned carb & tank, has 700 miles on it. when it gets full revs it runs like a bear! sometimes at full throttle it seems to run half then takes off & runs great. cleaned carb,tank&plug any suggestions?

Edited by DirtDemon
Posted

no, when riding it, it just won't go to full rpms. sometimes it will,also the the exhaust pipe gets red hot. if i remove the air filter tube & help the vacuum controlled slider go up, it goes to full rpms instantly! thanks for your help!

Posted (edited)

Sounds like you have an air leak. Red hot pipe + problems with a vacuum operated component tells me that you are sucking air in somehwere. My best guess would be it is between the carb and cylinder. With the motor idleing, spray carb cleaner around the motor. If you hear changes, that indicates that you are sucking in the carb cleaner and have found an air leak. You could also just be suffering from a clogged air cleaner.

Edited by DirtDemon
Posted

Merged your threads together, in the future, please don't post the same thread in different forums. If I am correct, you probably found the Artic Cat forum and posted it again after you created the first thread. No big deal, just keep it in mind in the future.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By randyoct
      Will the top end of a 400 fit a 366 the price is so much cheaper
       
    • By spigmef
      I bought a 2008 arctic at 366 with 120hrs. When i red line it in neutral is smokes blue a lot. When I put it in high range it has problems getting over 35km/h. I bought it and had to clean the carb. It ran ok after i cleaned it. Not I have this problem. 
    • By 97kingquad
      Okay so I bought this 1997 sazuki king quad from a guy and he had it for a few years. 
      He had it registered and on the trails last year but he said it bogged and backfired when he would try to drive it. so it sat for a year. 
      I bought it for 800 bucks and got it running that night and it ran great for a few days 
      But I parked it the other night and went to start it again and it was really hard to fire up and when I did it was bogging and idling high then low again.
      So I took the carb out and cleaned it (ended up doing it twice because it was still doing the same thing) 
      Now today I have it running slightly better, but it is still like 20% 
      I have been looking it up and trying to figure it out but I can't find the issue, has anyone else had this problem? I'll attach a video of it running and giving some throttle 
×
×
  • Create New...