Quantcast
Jump to content


Squeeky Shocks

Guest Fox300exchic

By Guest Fox300exchic
in General ATV Discussion

 Share

Recommended Posts

Guest Fox300exchic

Guest Fox300exchic

Posted
Posted
Yea, what MWKE said. Just take the mount bolt out and put a little grease in the shock eye, and put it back together. The same thing can happen with the steering stem mount.

^^ THIS ^^

Link to comment
Share on other sites
mywifeknowseverythin Grand Master

mywifeknowseverythin

Posted
Posted

WHERE is the Squeeking coming From???? Front, Rear,, All Around??? How about your Swingarm Bolt....Did you pull that and Check your Bearings???? Grease them??? If Grease doesnt help them then I would say order some New Bushings and it wouldnt hurt to order new Swinger Bearings if your going to go as far as Removing the bolt.. Other than that I dont know what to tell ya..:P When you do all this,,,,Just be sure to hold your Tongue Right and everything should be fine.....This maneuver usually helps mebiggrin

Link to comment
Share on other sites
Guest Fox300exchic

Guest Fox300exchic

Posted
Posted

ok Something happen to the post I made a few minutes ago...It didnt even show up. Seriously though..the sound is annoying. thumbdown

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • McG75
      1996 Yamaha Timberwolf 4x4 Struts and Shocks
      By McG75
      Hello I’m new here and was wondering is anyone knew of good replacement part numbers for front struts and rear shocks for this atv? I think I’ve found a new rear shock, that looks like the original but there is no dimensions or anything and was wondering if there are any afterMarket new front struts available. I know it’s a long shot but any help would be appreciated. 
    • BuckBilly
      The Official Good morning thread!
      By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • kawasig
      Good aftermarket carburetor
      By kawasig
      Hello there
      I'm having a problem finding a quality carburetor for a 1993 Suzuki Quad Runner lt-f 250 2x4. I find a lot that have 3-4 star ratings. And all so far don't have the right throttle Cable inlet at the top. The last one I got 4 star on Amazon has a threaded cable sheath rest that could be partially drilled to work. I would prefer to get one I don't have to modify. Any recommendations are greatly appreciated!
    • Sofaspud
      2008 Can-am Outlander 800 R hard shifting issues
      By Sofaspud
      My 2008 can-am Outlander 800r is having hard shifting issues. Does anyone have a fix for this ?
    • Am2007
      2006 Can-Am Outlander 400 XT Oil presure light is on
      By Am2007
      Hi everyone,
      Outlander 2006 400 XT i have replace the startor cover and right after i did that the oil light is on and not turn off, i check the wires and checked the oil level, everything seem to be normal quad is starting without any problem and rev just fine. i did not want to ride it since im not sure if it is faulty sensor or not so just be safe i did not let it run more the a minute or so. 
      I have read in the owner manual that i need to clean the oil strainer every 200hr unfortunately i never did that, my service manual that i have does not even indicate of such a thing. so i did some search around and it seem like canam split the manual into 3 parts
      owner manual
      service manual
      engine manual
      I have the first 2 but i can not find the last one, part number 219100232. If someone can guide me where do i find the oil strainer so i can clean it i will appreciate it.   im going to do an oil pressure test tomorrow to check how many PSI i have, just to make sure.
      Thanks

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...