Quantcast
Jump to content

Recommended Posts

  • 4 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By quadnut20
      Went for a solo ride up at Rollins Pass Colorado !! Elevation is around 10'000 ft 11'500 at the top but the snow stopped me but was still fun !!











    • By Freddie
      My first quad and I have a problem. I have a Kawasaki Bayou 300 1997. When I start it. It will go on high idle for about ten seconds before it goes down to low idle. It does this even when I don't touch the throttle or the choke.
      Also, when I give it some throttle and let go. It will come back to fast idle for about ten seconds before it comes down to slow idle. Therefore I have to wait for it to slow up before I can shift. The throttle linkage drops right back to the stop on the carb buy the rpms stay up for a while. If you have any ideas what might be wrong please let me know. thank you Fred
    • By CaptJim
      Hello guys, I hope I am not invading your space, but as you can see the current state of my project here it's not but about 50% ATV. I am hoping that some one here can point me to a wiring schematic that I can reference since the "Complete wiring harness" i purchased from Amazon did not include a diagram of any kind.

      The ones that I am finding on line vary greatly but none show the connections for the separate 5 wire connector coming from the motor.

      Can someone tell me where these wires go?
       
      Thanks in advance for all help!
    • By pjb274181
      Quad can turn very tightly to the left but very wide to the right.  On inspection, when turning right, the pitman arm hits the EPS controller - it doesn't when turning left.  The quad had been rolled (prior owner) and the steering was straightened.  I believe that the pitman arm is now slightly offset.  Can I disconnect the tie-rods from the pitman arm and then remove and reattach the pitman arm in a more centered position, and then reattach and adjust the tie-rods?  Or is the pitman arm not adjustable since there is a grove that it must align with on the EPS?  If not the method I suggest, how would a person fix the issue?  Would the entire steering system need to be taken apart and reassembled?
      Thanks very much!
      Phil.
    • By LesterL
      Been a member of other forums, but since I recently purchased a used quad figured I would join up.
      Live south of Kansas City, MO...
×
×
  • Create New...