can anyone help me with the choke problem??? Its driving me crazy!!!!!!!!
I took the carb off again. All jets are 100% clean, the carb is clean, I removed w clip and throttle needle, the C clip was on the top notch. I moved it to the middle notch (factory setting) and once again made sure the entire inside of the carb was clean, float moves freely. Assembled again and the bike will start on the first pull but it only runs perfect with the choke on (in the upward position). If I move it down I have to adjust the 2 screws, I can ride it but when I give it a good amount of gas on the throttle it bogs down. It especially loses power when I go up a hill. If I ride it with the choke on it runs great.
Could this be a valve issue or does the symptom directly point to the carb???
Someone please help me before I go insane.
I havent ordered a carb rebuild kit with the jets but i did replace all the rubber gaskets/o-rings. All of the jets are clean and not blocked up with anything.
Could my problem be related to anything else other than the carb? The fact the bike runs perfect with the choke on leads me to believe my problem is carb related. Anyone located in Connecticut on this board? Id be more than happy to buy you a case of beer if you took a look at it with me.