I'm sure you have all wondered about snorkels on your ATV and I have finally went for it and made dual snorkels for my ATV.
My quad, like most, comes with a factory snorkel So I removed that and put some 1.5" PVC out of it with two 45 degrees to get around the engine like so:
Then I continued off of that with a straight piece going by the engine and into the fender
then in the fender I used 3 90 degrees to clear make sure the wheel never rubs on it.
I dont have a good pic but I used a T pipe at the top part to split it into a dual snorkel (I had a single but the dual made a difference by giving it all the airflow it needed)
Here is a picture of the whole assembly if you are having trouble visualizing it
After all that I painted the PVC black then used clear tubing (refrigerator water line) to extend the factory vent lines from the rear drum and differential. This is very important...
here are some finished pictures (I dont have any from the OHV park but they have passed the creak test :D)