hi all

my cat only has 100miles on it and is in mint cond. since i bought it new in 2009 it has had what i believe to b a carb problem. going down a steep hill makes it want to stall. as soon as u r on level ground its fine.and at top speed it kinda acts like its starving for gas. u let off the throtel a bit n its fine. idels good starts good. hav taken it back to dealer several times. they eithor said it didnt do it or mayb bad gas. my friend says it sounds like the float level isnt rite. any advise would realy help.

Just purchased this 4 wheeler in June, now I need to replace 1 wheel bearing, 2 boots (on rear), figure just do both sides bearing & boots. Was told it had 2" lift kit on it.Read some where might need to get different boots since lift. Want to do upper & lower. Any suggestions on how to tell if it's lifted & boots I need?

Mid 80's 340 artic cat is going into a go cart just for fun i bought a new cdi unit the original plug was cut off when I got it. there is 5 wires 2 yellow, a red a white and a brown my new cdi has 5 also a  lt/green a blk/wht abrwn, a black a blu/grn is there a wiring diagram I can use for reference or which wires go where a y help would be greatly appreciated jated.  BTY I'm  Derek and new to this forum I am actually trying to help a friend with project and learn a little in the process

Does anyone  know how to repair the gauges on these bikes? It's a well know problem. What component goes out in the display to render them useless? Anyone use a universal  one on their bike since the factory ones are so expensive?
 .

My 2005 Artic Cat ATV (250, 2x4) started up and I started to move when it abruptly stalled and died. Now when I turn the key, nothing at all happens. The "N" indicator doesn't light up, the motor doesn't crank, nothing. Any clues as to what might be the problem?