Quantcast
Jump to content

2007 Zoo Eiger Need picture HELP!!!


hojnowsr

Recommended Posts

Could the owner of a 2007 Suzuki eiger 400 4 x4 automatiic PLEASE take a picture of the fuse box that sits under the seat and send it to me????????via this forum

I need to get a look at the whole fuse box--- that is both sides--side that holds fuses and the other half which I think is either open or houses a relay of some sort??? I think I am missing a relay ??????????

TX BOB::biggrin:

Link to comment
Share on other sites

Snap a picture of your fusebox area a post it here. I could tell yah right away if it's missing the relay if it's similar to my machine. Mines a 2002, but still shoild be similar. I pulled my relay out and it sure looks like exactly whay you said in your previous post.

Link to comment
Share on other sites

  • 2 weeks later...

I took a few pics of my fusebox area. (don't mind the white Type-R or white connecter block, that's for my LED strobes.) the rest is stock wiringh and the starter relay is the black box that says DENSO on it.

Facebook

If that link brings you too my albums, just look under the Quad Fusebox Pics, hope that helps.

Edited by Mudflap64
Added comment for reference to photo's
Link to comment
Share on other sites

Found the part I need it's a Densco (sp?)relay that goes in the fuse box under the seat # 016700-4430

does anyone know where I can order it??/

TX BOB

Do you mean "Denso #061700-4430" Check Ronnie's Mail Order for atv parts, atv tires, snowmobile, watercraft and motorcycle featuring an OEM microfiche parts finder. , they might have one. That is a very common relay, same as mine.

Link to comment
Share on other sites

  • 3 weeks later...

tx for diagram figured out the quad is a 2008 and has a different wiring set up. Got missing relay from Ronnies , it came and is right BUT still will not fire up I know think the starter relay is shot. When I depress the started button the starter relay clicks and then the electric goes off. BUT comes back on in a few minutes --like some sort of relay resets itself--- shops are super busy and so I think I'll just buy a new starter relay and see it's the problem.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Uglyside38
      I have a 1988 Quadrunner 250 2wd. My brother in law sold it to my son for $20...had been sitting outside for several years. Got it home and had it running in about 30 mins. Ran it a bit and then went to looking at the carb as it was having trouble idling. Was getting it pretty close, then started losing spark...Also, it wouldn't start up every time...only about 1 in 5 tries. Anyway...now, it has what I can only describe as "intermittent" spark. I can get 1 light spark right when the start button is pressed and sometimes one when it's released...but none while cranking. 🤷‍♂️

      I have replaced the spark plug, ignition coil/wire, and traced wires best I can. I noticed a couple frayed wires at the pickup coil where it enters the case. So, now I have the cover off, stator and pickup coil out and trying to test the coil. I do have about 114 ohms resistance for pickup best I can tell. And I can read minute voltage when I drag a magnet across it. Could it still be bad? Can a bad ignition switch/button cause this? (I did have the switch off to oil the choke cable)...pulling rope makes no difference though...any ideas or help would be greatly appreciated!!! It's the intermittent part that's throwing me off! 

    • By rgeiser
      View File 2003 Polaris Ranger 400-500 service manual
      2003 Polaris Ranger 400-500 service manual
      Submitter rgeiser Submitted 04/18/2024 Category Polaris UTV  
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
    • By Louznmemind
      Howdy y'all, I'm trying to fix a neighbors 2015 Brute Force 300. Came in with hard to start and won't idle except on choke issue. I pulled the carb and found the pilot jet as well as the emulsion tube partially clogged. Cleaned up everything, put it back together, still having issues...  It will start right up on choke and will also start off choke if you give it just a touch of throttle but it absolutely will not idle unless it's choked just a touch. Also, excuse my ignorance but I'm assuming the "dial" thingy attached to the carb that turns in and out is for setting idle?? 
×
×
  • Create New...