Quantcast
Jump to content


87 250 quadrunner...won't crank when temp drops to 50 degrees F.


s87kwadrun

Recommended Posts

New to the forum---wondered if anyone had any thoughts on my start problem:

All summer, my old 87 Suzuki starts great. Once the weather starts to cool, when I push the start button, i get nothing but a click. Maybe the 5th to 8th push, I may get a start out of it. Once running and warm, it starts fine all day. Next day...same issue (if it's a cool day) .

Any ideas would be appreciated. Thanks!

Edited by s87kwadrun
Thanks...
Link to comment
Share on other sites

New to the forum---wondered if anyone had any thoughts on my start problem:

All summer, my old 87 Suzuki starts great. Once the weather starts to cool, when I push the start button, i get nothing but a click. Maybe the 5th to 8th push, I may get a start out of it. Once running and warm, it starts fine all day. Next day...same issue (if it's a cool day) .

Any ideas would be appreciated. Thanks!

How old are your batteries ?

Link to comment
Share on other sites

battery is not "new" but I have not charged it in 2 years. Just hit and miss last winter with the start. Fine with daily use all summer, then "clicks" today (cooler temp) until the 6th starter push, a decent sounding start. Seven starts in 1/2 hour (moving firewood) ...no problem. If it's cool tomorrow, I expect to go through the clicks again, like last winter (many days it did not start). Very weird (at least for someone with my limited know-how :) ) Thanks.

Link to comment
Share on other sites

Thanks for the suggestions. I thought about the battery, but after the short hops today and the multiple decent starts (not enough time to recharge the battery) I was thinking maybe not. But if the cold crank amps are not there, I get where you''re going. I'll have to see if I can load test it tonight. Thanks again guys.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By Uglyside38
      I have a 1988 Quadrunner 250 2wd. My brother in law sold it to my son for $20...had been sitting outside for several years. Got it home and had it running in about 30 mins. Ran it a bit and then went to looking at the carb as it was having trouble idling. Was getting it pretty close, then started losing spark...Also, it wouldn't start up every time...only about 1 in 5 tries. Anyway...now, it has what I can only describe as "intermittent" spark. I can get 1 light spark right when the start button is pressed and sometimes one when it's released...but none while cranking. 🤷‍♂️

      I have replaced the spark plug, ignition coil/wire, and traced wires best I can. I noticed a couple frayed wires at the pickup coil where it enters the case. So, now I have the cover off, stator and pickup coil out and trying to test the coil. I do have about 114 ohms resistance for pickup best I can tell. And I can read minute voltage when I drag a magnet across it. Could it still be bad? Can a bad ignition switch/button cause this? (I did have the switch off to oil the choke cable)...pulling rope makes no difference though...any ideas or help would be greatly appreciated!!! It's the intermittent part that's throwing me off! 

    • By N00bie
      From Arkansas. Just bought a 2012 Gator 850i RSX because I could not pass up the price. BUT it has an idle problem. So, to be honest, I joined just to get a service manual. I have a choice: 1)Buy a hard copy: ~$100; 2)Buy a CD ~$35.00; Get a direct download for free posting 10 times; or get a download for $29.00 (subscription). Haven't decided what to do yet.
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
×
×
  • Create New...