Quantcast
Jump to content

2003 LT160 Quadrunner Cold Start problem


copedaddy

Recommended Posts

Just joined the forum and was hoping to get some advise on a problem Im having with a new quad I picked up for my son.

Its a 2003 LT160 Quadrunner. When I bought it the guy said it ran fine and was riding it when I got there. It ran great, good power, idled fine, etc. and restarted easily. when I got it home (90min ride) it would not start and killed the battery (which I knew was weak already)

The next day I charged the battery up and still could not get it to start. I tried choke on and off and throttle one and off with no real difference . The very 1st crank it sounded like it wanted to fire, but after that it just turned (does not sound like it is firing). I removed the air cleaner and gave it a shot of starting fluid and it started right up and kept running great!

Let it sit a week, got a fresh battery in it, topped off the fuel and got basically the same thing. 1st initial crank it tried to fire and nothing after that.

Any ideas what might be going on that would cause it to not start unless I use Starting Fluid?

So far I have not taken apart anything to troubleshoot.

Thanks!

Edited by copedaddy
Link to comment
Share on other sites

Gas is fresh. Called the seller and he said the dealer just did oil change and inspection on it before he sold it. Only thing I can think of is somehow a piece of trash came loose in the carb during the trip home and somehow if preventing gas from getting to it.

Does this make sense?? How will it run fine after starting on ether, but wont get enough gas to initially start?

Link to comment
Share on other sites

I would check the choke parts fisrt:make sure its working properly, i have a couple machines that dont have a choke and i have to start them with ether..If no problems there i would then say its a fuel delivery issue: an idle set too low for cold starts, or a problem in the small/idle port in the carb. Hope this helps..(also check the spark plug make sure its clean and working properly, sometimes we over look the simple things)

Link to comment
Share on other sites

  • 2 weeks later...

we are in the same boat here, I have a 2003 lt 160 also and cant get it to start without fluid. maybe I can save you time, I have replaced battery and spark plug. tore the carb apart and cleaned it. replaced both jets in the carb also. I put gas treatments in it, new air filter. nothing has worked. my choke is broken so im going to try to work on that next. this is all new to me, got tired of paying labor prices.

Link to comment
Share on other sites

  • 9 years later...

I had that issue happen with me not long ago. I took the tank off and started running vinegar, baking soda and dawn in it and I found a bunch of crap in the tank that you can't see on the quad runner 160's. I noticed when I turned the petcock valve on all kinds of black stuff was coming out of the tank stopping up the petcock valve. The cleaning solution started out strong and shortly after I noticed while cleaning the tank the flow would get weak. Ive had my tank off a handful of times cleaning it trying to make sure all that crap it out. I don't currently have choke on my four wheeler so I have to let it warm up for a bit before riding it. Both of my 160's are cold natured so it seems to me that it's become a common thing. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Uglyside38
      I have a 1988 Quadrunner 250 2wd. My brother in law sold it to my son for $20...had been sitting outside for several years. Got it home and had it running in about 30 mins. Ran it a bit and then went to looking at the carb as it was having trouble idling. Was getting it pretty close, then started losing spark...Also, it wouldn't start up every time...only about 1 in 5 tries. Anyway...now, it has what I can only describe as "intermittent" spark. I can get 1 light spark right when the start button is pressed and sometimes one when it's released...but none while cranking. 🤷‍♂️

      I have replaced the spark plug, ignition coil/wire, and traced wires best I can. I noticed a couple frayed wires at the pickup coil where it enters the case. So, now I have the cover off, stator and pickup coil out and trying to test the coil. I do have about 114 ohms resistance for pickup best I can tell. And I can read minute voltage when I drag a magnet across it. Could it still be bad? Can a bad ignition switch/button cause this? (I did have the switch off to oil the choke cable)...pulling rope makes no difference though...any ideas or help would be greatly appreciated!!! It's the intermittent part that's throwing me off! 

    • By rgeiser
      View File 2003 Polaris Ranger 400-500 service manual
      2003 Polaris Ranger 400-500 service manual
      Submitter rgeiser Submitted 04/18/2024 Category Polaris UTV  
    • By N00bie
      From Arkansas. Just bought a 2012 Gator 850i RSX because I could not pass up the price. BUT it has an idle problem. So, to be honest, I joined just to get a service manual. I have a choice: 1)Buy a hard copy: ~$100; 2)Buy a CD ~$35.00; Get a direct download for free posting 10 times; or get a download for $29.00 (subscription). Haven't decided what to do yet.
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
×
×
  • Create New...