Quantcast
Jump to content

  • Do you own an ATV, UTV or SxS? Join our Community Forum!

    QUADCRAZY ATV Community and Forum are FREE to join! We keep our ATV, UTV, and SxS forums clean and user friendly. All first time posters in our forums will have to wait to have their content reviewed and approved. Once your first ten posts are approved, you will no longer need to go through a forum post approval process. To bypass the approval process with immediate access and a NO ADS experience in our ATV, SxS, and UTV forums, consider subsribing to a Premium Membership

07 kingquad 450 4x4 button issue


nonstuck

Recommended Posts

Hi,

New to the site, and atv's, but have been riding on 2 wheels forever.

I just purchased an 07 king 450, and didn't notice til I got it home

that 4 wheel is displayed on the gauge all the time. This is regardless

of the position for the push button 4 wd. I haven't had the opportunity

to put it up on blocks to confirm all 4 are turning. Is there a fuse

or something that is causing the display to be constant ?

This rookie is open to any and all advice.

Thank you in advance.

Link to comment
Share on other sites

So then it would be logical to assume that there is a gearshift position sensor that is stuck on even though it is only supposed to be activated when the machine is shifted into 4wd. There is a gearshift position sensor located on the outside of the engine case, I am not 100% sure, but I think it would be on the left hand side as you are sitting on the machine, but check both sides as I am not sure. It is a small plastic thing with two screws holding it in and wires coming out of it. There is a small pin that allows the gear shift shaft to turn the switch portion of the gear position sensor. I would suspect that either there is a problem that is not allowing the switch to be turned, or the sensor/switch itself is just bad. This same switch should probably activate a Reverse light, does the reverse light work properly? Good luck.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...