Quantcast
Jump to content

2000 Suzuki QuadMaster LT-A500F Does Not Run


JPEDRO

Recommended Posts

Hey, I have just bought this quad. its in decent shape, but does not run. its turns over and is getting fuel and has to what seems to be good compression(just going by finger over the plug hole and turning over. but it wont run due to no spark. i did have it making spark but not very good. where do i start? i put on a new plug wire and new plug what next how do i tet and search things? im new at this stuff diesel engines i know like the ack of my hand but this i am a complete newb. what would be the first thing on a list to check and how tos. all help is greatly appreciated. thanks

Link to comment
Share on other sites

The first thing I would do is purchase a repair manual, it will have some direct resistance tests for some of your ignition components as well as a troubleshooting guide. Most likely problem is a bad coil, CDI, pickup coil or just a loose or corroded connection somewhere. A visual inspection of everything behind the stator cover and all the ignition wiring and switches would be a good place to start, but I would strongly recommend getting that manual.

Link to comment
Share on other sites

I would check for power into and out of the coil by the use of you ignition diaphram. if you have power in and out then i would test for ground in the circuit by putting the test light to power on the gatorclip and touching the ground wire in the plug. if all is ok then replace the coil. if you had weak spark then no spark i would suspect a wiring issue or a poor battery as well.

your friendly neighbourhood mechanic.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Mhatayas
      My uncle bought a Baja 250, 2006. Knew there was no spark since the get go. He don't know anything about quads so is getting me to help him try to get it running...
       
      battery is bad so I connected battery charger to it to crank it over , cranks over well , but no spark .... 
      Lights and everything work fine , but with each crank over using the e start switch , the display reads 999 888 777 666 ... Right down to 000 and repeats itself . 
       
      He managed to get a parts bike , I changed over the CDI and the coil and the stator from the parts bike and there was another black box by the voltage regulator I changed over ... I used my multimeter to confirm as much as I could works , it's hard without knowing which wires are which , and I cannot find any diagrams online for this bike ? 
       
      Do you think it could be the Killswitch? There's so many wires coming from there I don't know where to start . Also I should mention it appears the fan on the front of the bike has been taken off (the wires have been cut too ) 
       
      If this bike sparked it would run . The previous owner said he parked it one day and it just wouldn't start after.
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
    • By Tuzz
      Bucking started about a month ago and works ok after 1/2 hour warmup.  Today while working on it i discovered that if i put the ignition switch in LIGHT position it runs fine right from the start.
      I'm stumped!  Any idea why this could be?  

    • By DarkRider
      This is something I'm extremely curious about. Has anyone ever attempted to buy a quad (or any other vehicle) from an impound lot? I've always wondered if this could be a bargain, or a waste of time. Google searches do turn up some helpful results. Looks like the state of NJ holds auctions online which I'd be a bit hesitant about.
       
      My online searches haven't really turned up any results of anyone buying an ATV this way. I'd be really curious if anyone tried this, or knows someone who has. I've actually found a couple pages with online auctions for my state, but none had ATVs.
×
×
  • Create New...