Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

RichUncleSkeleton

1999 Suzuki King Quad lt-F300F Hard to start

Recommended Posts

Hello

Just signed up, as I've had a recurring problem, and need some help.

To start the bike I have to put the choke on all the way and 4 squeezes on the gas, Then as I push the start, I slow squeeze the throttle about half way for it to catch....If I miss it, then it will take 5 mins of slowly finding the sweetspot on the choke in unison with some throttle squeezes.

Then I have to to hold the throttle to keep the bike going, using the choke will stall it out. after about 3 mins of holding the throttle, I then can let it go, and it idles fine, and runs fine. If it sits for a few hours it's only slightly hard to start, but a few days of sitting, and it's a lot more work.

Had the bike serviced they couldn't figure it out. They swapped peticock, plug, new gas, all new lines, new throttle, and cable. Said the carb was fine, and clean. New air filter, said fuel pump was fine, no leaks around carb boots, new battery, new rectifier.

Ran some sea foam through it....Runs Great.....Just such a pain to start...

Thanks

Share this post


Link to post
Share on other sites


Hello

Did a lot of reading on this site, and have had some good luck. I shortened up the vacume line from the petcock to the carb, and discovered a small leak in the crankcase where it comes together. The gasket must be gone if it has one there.

Used some chemical resistant cement to seal all along the seam, and snugged all the crankcase bolts. The leak was a drop every 2 days or so. And now it starts up everytime, but I have to keep giving it throttle for about 3 minutes, then it will idle on it's own. When I try to give it a little bit of choke to keep it idling, it just floods it, and it will quit.

So now the bike starts fine, but I have to nurse the throttle for 3minutes to get it to idle on it's own, while applying the choke will kill it.....

Any thoughts...?

Thanks

Share this post


Link to post
Share on other sites

I ended up replacing the vacuum petcock with a manual and replacing the fuel pump on mine with a cheap honda one. I dont trust vacuum petcocks, they are always a source of mystery running problems on older bikes.

maybe your floats need adjusted? bad float needle or seat? I know the shop said they were ok but it obviously isnt running right.

Edited by Krudiak

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Frank Angerano
      Not sure how many of you will remember this or give a crap about it but back in 2016 I picked up my first old atv to rebuild. Yamaha bear tracker 250. I picked it up in NJ while I was out looking for a quad for my little guy since he started this atv thing after seeing a few old pictures of me in my hay day riding. 
       
      The person I was getting the 50cc quad had this one laying around and asked if I was interested in it.  It was beat up and hadn’t ran in a few years.  No spark the guy said and he left it to sit.  I wound up taking both bikes. 
      I wish I had pics but I deleted the original post on Quadcrazy and lost the old ones on my phone when I upgraded. 
      This was the atv that caused me to stumble upon Quadcrazy since I needed a little help with the spark issue.  So needless to say I fixed it, did some cosmetic work and she was good to go. I took it upstate and used the shit out of it for just about everything under the sun. This atv made it through some deep snow, mud etc. I decided to leave it up there and use it as a back up since it’s been about 50 atv’s later and I have newer machines now. But unfortunately it sat for some time and it’s a little beat up so I brought it back home and going to clean it up. Amazing how one year sitting has done so much damage. 
      This was the first atv that I owned in over 30 years! It’s the atv that brought me here to Quadcrazy where now I endlessly check the site to see what’s going on, who’s talking about what and who can we help with there problem or can help me with mine as well as the on slot of what I do today as a hobby with atv’s. It’s been a great pass time for me and my son with the projects we have gotten and get into. He’s learned how to ride so well it scares me a little watching him. He’s learned how to fix, maintain and upgrade atv’s. He’s insanely good with carburetors as well. 
      It’s a good thing when a kid wants to play in the garage over his X Box!!
      The funny thing about this bike is that when we finished it we thought it was the best thing! We were missing a rack on the front and didn’t care since it looked ok, had no clue where to get parts or how to fix plastics. I was so new to this again since I was staring all over again and now had to remember things and also teach my son!  
      So we will be tearing into the bear tracker to get her up and running again as well as maybe a few new cosmetic changes and hang on to her for a while since I love this bike.  The last two pics are the bike the day we finished putting it all back together and when it was upstate for the first week. 
       
      Had no intention of this post going so long. 🤷🏻‍♂️







    • By bradleyheathhays
      So this '02 Taurus with only 87k miles on her starts right up every time multiple times a day except for twice in the last 3 weeks. The first time was 3 weeks ago and the second was today. It happened the same both times. Turn the key and stop to let the pump prime, then when I turn to the start position the engine turns real slow and sort of in fits. Usually when a battery is low the engine turns slow but in rhythm. During my 2 starts the engine barely seemed to turn and the crankshaft rpm seemed to vary. On both starting events I let off the key and tried to start 2-3 times with rests in between. But then eventually on the 4th try it starts right up just as quickly as a normal start.

      I have No clue as to what might be causing this. Only thing I know to do is, next time it does this to put a voltage meter on the battery to see if it's weak. Actually though, because both events the engine ended up starting up like normal that would indicate something other than the batt. Electrically this car is a little odd though. The interior light never comes on when the doors are opened, for years, and then last week it comes on twice when one of the rear doors is opened.
    • By Kaj Colum
      Pushing the start button the engine turns and will forever without starting. But if I use the kick start it will start with one or two kicks everytime, any idea as to what is going on. New good battery and coil, I'm ready to try anything. It's a great bike, but this is getting anoying. Thank you.
    • By Kaj Colum
      Have a Bayou 400. sometimes when I press the start button i hear the solenoid click but the starter does not engage. Here is the strange thing though, when that happens if I kick the kick start just once then press the start button starter engages normally. Any ideas?
       
    • By bradleyheathhays
      Last time I installed a remote start system it was on an old Dynasty whose wiring was too delicate to work on really. A couple weeks after installation it started ok but a ton of white smoke came from under the dash. I uninstalled the entire system and everything was fine after that.

      So in picking out a starter for this '02 Taurus I want something simple that will work with this car well. The start systems I'm seeing are generally designed to do door locking and unlocking, trunk release, etc. As this car already has those functions on a fob I won't be using any function on any future remote start system other than the remote start.

      Can anyone with knowledge of my car recommend a decent but low cost / low extra functions start system that would work well with my Taurus?

      Thanks
       
  • Similar Tagged Content

    • Guest Fox300exchic
      By Guest Fox300exchic
      The Hop-Up: You may be saying to yourself, “that’s a chick bike,” and you’re right. But honestly, it’s so much more than that. It’s one badass bike. http://www.quadmagazine.com/quad/features/article/0,24942,1587044,00.html
    • By Jers
      I need to know what I have and what tire really go on it, Mine has 24x11x10 on the back and 22x8x10 on the front and I need new tire but I don't think are the right size. Also I can't find the model number listed but it looks like a 250 quadrunner 2wd and I think it is a 1987 maybe, can anyone help me, also I it has a rich running sound and I put a carb diap in it and cleaned the carb. is there a jet needing replaced?
    • By skgw1
      Feul pump went out. Replaced. At times quad cuts out like its not getting gas. Saw article on new pump needs to be calibrated. Told how to go into a service mode. Does not tell how to calibrate after going into mode. Can anyone shed light on this procedure.
    • By Suzuki24
      I have an 04 ltz and it started sputtering a little bit while going down the road and I was low on gas so I just figured that's what it was. But now I can't get it to start I completely cleaned the carberator put a new spark plug and coil pack in it and all it does is turn over. It has compression it's getting fuel and it is sparking but all it does is turn over any idea what it is??
    • By izzydum1
      Any ideas on what would make a coil not fire? She was running fine, then began slow start. Now wont start at all.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...