Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

higdon87

06 ltr 450 spits and sputters

Recommended Posts

I have a 2006 ltr 450 the starter is out on it but you can roll start it 2 days ago i rode it took a lil longer than normal to start but it started and rode just fine. Put it in the shed went to ride it tonite was even harder to start but finally got it started. When you go to hit the throttle it cuts out then it clears up and then would be fine if you bumped the throttle or was about half throttle. If you went full throttle it would bog down spit and sputter and the longer you did it would lose power gradually until it finally died. Any ideas on what it could be thanks in advance and this is my first 450 fuel injected quad

Share this post


Link to post
Share on other sites


Fuel filter is the first thing I would check. If it's not that,, keep following the fuel system to the pressure regulator, then to fuel pump, etc...

  • Like 1

Share this post


Link to post
Share on other sites

I agree with yooperman19, sounds fuel related. Check those items and then look at fuel regulation. Sensor, pump, etc.

Share this post


Link to post
Share on other sites
On 10/13/2016 at 8:19 AM, higdon87 said:

It was fuel it was the cdi box changed it and runs fine now

 

Good to hear!

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By dave3dracing
      Hi, I'm a new member
      Just bought a used 08 350 raptor with about 5 hours on it ( very clean ). Started fine when we got it. Now after a few mods (bumper, skid plates, air filter) Now will not start unless you pull in the clutch. I've checked just about everything and also checked that there is no pinched wires. Anybody have any ideas?:bangheadc: Thanks, Dave
    • By payne
      Have an Bear Tracker 250. Dont have the manual or any literature to help with. Anyhow, starts with pull start in gear, and electric starter doesnt work. Also, neutral light doesnt come on. Where should I begin?? Need some direction on troubleshooting all this. Thanks a million.

    • By Frank Angerano
      So i took a road trip today to look at a Suzuki Eiger! 2006 in perfect condition other then the fact it starts for 30 seconds and shuts down.  
      Its been sitting for about a year in a shed. 
      It has a plow and a winch included!!!
      Got it for a really good price and all looks good so far.  
       
      Stay tuned.  





    • By Jack Briggs
      Just bought 06 KingQuad 700 and first ride out hit a mud hole, not to deep and it shut off and would not start. 
      Got it home and found the spark plug hole was full of mud and water. Went and bout a new spark plug and began cleaning it out. Put a deep socket in there and it wouldn’t grab. Took a pic with my flash and this is what I see. Any suggestions? And what is it??
       
      previous owner said it had a new coil so that’s why I decided to change out the spark plug, also ordered new coil should be here by the weekend. 


  • Similar Tagged Content

    • By Michael Aiken
      Where can I find a wiring diagram for my 2005 450 Kodiak. Thanks.
    • By Kristpj
      I know this tooic has been addressed by many, I’ve looked through many forums and pages. I did not find anything like the problem i have.
      I have a 2007 Kingquad 450. I have a new fully charged battery. When i turn the key, the dash flashes and seems to struggle before getting fully lite. We can hear a small relay near the computer clicking, i think it is the fuel pump relay. When i turn off the engine kill switch and press the starting button relays click and all the power shuts off, i turn the key off, engine kill switch then start over, power is there. Atv will start with pull start, but not elextricly. if i try to use my winch, all power cuts and engine dies. 
       
      Can anyone tell me what it may be? or has anyone fsced an issue like this before?
    • By chuckufarlie
      I have a 2018 Kodiak 450 EPS that just this past Sunday I ran through a bit of water.
      After the puddle the belt was slipping, so I pulled over and drained the ultramatic housing and the slipping problem went away. This was all in L and everything seemed to work fine. Later when I got on a road, I put it in H, but it still rode like it was in low... i.e. I had to rev it up a lot just to get to 30mph.
      When at home I pulled the ultramatic cover off to inspect, and it looked okay in there. Not much dirt, belt and everything are clean, but when I rev up the engine (with cage in place, of course), the belt doesn't get to the top of the clutch (maxes out about an inch or 1.5" from top of clutch, so maybe it is normal).. I put it back together but same thing... H seems like L still.
      Do you think the clutch needs to be further dissected for cleaning, or could this be an issue with the gear selector?
       
    • By Steven Alter
      I have a 2018 450 and the digital gause has started flashing on an off while driving. The backlit also goes on and off. It is worse when I hit the gas. The battery died a few weeks ago and I jumped it but its been fine until last night. Called the dealer and showed them a vid and they recommend replacing the gauge and its like 600 bucks. The machine has less than 100 hours on it. I would really hate to have to change it out. also the unit sometimes has trouble starting. Any ideas?
    • By Admin
      View File 2014 Arctic Cat 450 ATV Service Manual
      2014 Arctic Cat 450 ATV Service Manual
      Submitter Admin Submitted 02/08/2019 Category Arctic Cat ATV  
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...