Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Dan Ellsweig
I have a 98 Polaris Magnum 425. Runs GREAT for 10 minutes then starts to load up (sounds rich) and looses power. Final;ly just stalls out on idle. If it sits 20 minutes will run again.
replaced fuel, added fuel treatment (seafoam), Replaced plug (carbon fouled), plug wires, air and fuel filter, checked all fuel and vac hoses, REPLACED carb with new. Still no good. Just ordered a coil, not sure if that will help
Note: both the new and old carb only had the idel adjuster screw - cant find the jet adjustments or air/fuel mix screws so I cannot say how they are set.
Looking for ideas short of spending big $$ on Polaris service
By Tyler Reed
Came here for help, If it’s in the wrong place I’ll move. I’ve got a 2000 model Polaris Magnum 500 that runs strong as can be for about 25 mins until warm, then sputters and loses power. Took it to a shop and they say it’s low compression and they will have to swap the entire engine. Seems a bit much and costs more than the entire bike. Was wondering if anyone has seen this and what the fix was. When I hear compression I think of gaskets, not an entire engine. Seems like if it was that bad it wouldn’t have power cold. I’m at a loss. Any help is appreciated greatly.
By Steven Urban
First time using this forum. Owned a Kawasaki dirt bike once, had no issues. But I picked up this 4 wheeler at an auction. They stated it ran, but only needed a battery. Well I do not believe that was all true.
Some pictures are attached. Not sure why, but the whole air filter stuff was removed. They had some small thing inserted as a make shift air filter.
I purchased a battery to try this all out. Waiting to return it and get the proper size, as it was too big for the battery box. But here is my issue I had while the battery was connected.
1 - The lights on the steering column did not come on. Not sure if they work or not.
2 - The starter solenoid seems to be bad. I have a new one on order.
3 - In the pick, there is another rusted part. Not sure what that part is or what it is used for.
4 - What is the 12v rectifier? square bodied part.
So when I hooked the battery up. Pushing the start button did nothing. Pulling the cord to try and pull start, it turned, but would never fire. I have put in a new spark plug as well, it looked worn out. With electric start, I crossed over the posts on the start solenoid, it turned over, but would never fire and start.
I have read a few other threads and it stated something about needed the neutral light on. SOmething about a kill switch.
Any help would be appreciated.
Need help with a 2007 polaris phoenix 200 no spark new cdi,new ignition coil,checked resistance on pulse coil and stator,not getting power to start button now guessing the solenoide went in all the testing not sure.also have three ground wires to battery is this normal or..?
Recently Browsing 0 members
No registered users viewing this page.