Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Brian Simmons
A buddy of mine . had a friend redo his top end . It was running great . then it like locked up but then it started again !!! then it seemed like it locked up again ??? Could he have done something wrong ??? Could it be bad ??? Please let me know what you think it could be ??? Please help !!! i want to know how much it will cost to fix or if he should part it out ???
PLEASE HELP !!!
I have had this ATV since new, and no work done on the system before. It has an intermittent issue with starting for years but getting worse. Cranks but no start or have to cycle power. No Codes. There are times it starts right up and then times it will not start at all.
What I have done, new plug, new battery, new coil. Also, the manual I have has spec info for the H1 & H2, but when I check ohms & AC voltage & wire color, it is more in line with the H2 than H1.
Ok here is what I have done.
1. new plug then new battery.
2. checked and replaced the coil- primary was 5ohms and secondary was 20.4K ohms. Since my book said for the H1 the Primary should be less than 1ohm I replaced (new one had the same 5ohms, confused! H2 says 4.8ohms). Book says secondary should be 12k-20k ohms and it was 20K ohms. New coil did not correct the issue.
3. Stator, AC output while running was good, about 75 volts AC no load between the three yellow wires (but mine are gray wires like the H2). Ohms were also less than 1 ohm.
4. Crankshaft position Sensor. Again, H1 should have Blue & White but I have Blue & Green like the H2. I have 180 ohms across the Blue & Green wires, so this is good. But when cranking I have 2 volts AC. For the H1 book says 5 volts AC. But H2 says 2 volts AC.
So, is my position sensor putting out low voltage or do I have the stator assy for an H2 in my H1 ATV from new? Stator & position sensor are one assy. Has this ever been an issue that was noted? New Stator is $$$ so I don’t want to just shotgun a part.
Any help would be great!
By Curtis Hicks
Ring and pin stripped out along with rear axle ... gonna cost me about 2gs to have it fixed at the shop with all new parts ...wondering if anyone knows of any other bike that would match up or if I could replace whole thing from driveshaft back or from motor back ? ...very broke when it comes to putting money into this bike just want it to ride again lol ....any help out here ?
Hey I'm looking at purchasing a 2006 Arctic Cat 650 H1 SE but don't know much about Arctic cats, how reliable are they and will it make a good Mudder/work horse?
Here is a link to the one I'm looking at
Sent from my LM-Q910 using Tapatalk
Similar Tagged Content
Looking for Arctic Cat ATV VIN (Vehicle Identification Number) Number Decoders? Once you find your ATV VIN number off the tag on your Arctic Cat ATV, you can go to all kinds of websites that have VIN Decoders available. The best ones are backed by the Arctic Cat ATV manufacturer, however there are plenty of aftermarket Arctic Cat ATV VIN Decoder websites on the web. This topic will stay pinned and if you find any to add, please do it with a reply.
The following Arctic Cat ATV VIN Decoder websites are available where you can just enter your VIN number and it will shows you some of your ATV model details:
NICB Theft Check https://www.nicb.org/theft_and_fraud_awareness/vincheck
Hey yo quadsters, I have a question regarding CCA in batteries. My ATV is cold natured and it will start with my generic battery that's in it, (don't ask me now what battery I have in it cuz I'm at work,) but when I hook up an external battery storage unit (Beatit 1200Amps QDSP 1200A Peak 16500mAh 12V Portable Car Lithium Jump Starter) for quick jumps it fires so much faster. Which by the way is a bad ass accessory to have around. I keep the battery in the quad fully charged all the time. My question to the pros is how much difference does the CCA of a battery contribute to the quicker start?
By Craig Butterworth
Hi, i'm looking for some help and advice with my arctic cat quad, its the first of the arctic cat quads as far as i know, manufactured in 1996 the bearcat 454. i have owned the quad for about 10 years now but just recently it has developed a problem with reverse gear, reverse wont engage any more like it used to 😕 the cable and handle is free but there is no movement the gearbox end, can anyone give me a heads up of what is involved to fix this? 🤔
If anyone has a service/repair manual available for it as well that would be greatly appreciated! 🙂
Recently Browsing 0 members
No registered users viewing this page.