Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Matthew Richards

new head adjustments

Recommended Posts

I have a 2002 Yamaha Warrior 350 and i have a couple questions

1) On a brand new head would the valve clearances be set out of the box or would they need set?, bc i dont have a gauge and need to know weather or not to get one.

2) Will a brand new head come with valve covers and timing chain side plate?

 

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By ray desocio
      I posted earlier looking for a wiring diagram, but maybe someone can help me with the problem if they’ve had it before. 
       
      The quad Will start and idle ok, when I open the throttle it will rev all the way up until WOT and then it dies back down to idle, and if I keep the throttle wide open it will rev back up. It will do this over and over and over. 
       
      I replaced the carb, (twice), Rectifier, battery, and spark plug.  The Stator ohmed out to the proper specs from dinli.  The other issue i can see is I’m not getting 12v on the choke circuit. The lights don’t work either. 
       
      possible bad key switch? Maybe the new rectifier is bad? All the contacts on the key switch also ohm out properly    
      comprsssion is up to 125 psi and spark is there. 
       
      Reed valves look great.....
       
      im at a loss. Any trouble shooting advice would be appreciated. 
    • By T_bell40
      Question: Do you have to take gas tank off to get carburetor off the quad. ?? 
      It's gummed up again and needs cleaning. Put Sea foam in tank hoping it would dissolve any crud. No joy
    • By Colin Davis
      I recently acquired a Yamaha bear tracker 250 that does have a wiring harness.  Does anybody have a wiring diagram for the 250s. Also if you have a pin diagram that tells be the colors of the wires going to the cdi and rectifier or just a picture of the plugs would be much appreciated. I can’t find anything on the harness online. I have all of the switches and stuff and I plan on just build a harness myself because I can’t find one to buy.



    • By Larry Fox
      Has anyone had any luck putting a different gauge on this machine. Would you happen to have the wiring diagram? 
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...