Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Aidan

1984 Honda trx200 no spark

Recommended Posts

Hey

so this is my last resort. My 1984 Honda trx200 does not have spark. Note: I can’t attempt any repairs until 1/2/19

Ill break everything down. 

Pre-Issue: 

Before the problem started. I noticed the atv was having a hard time starting and would stall out often. I assumed this was because of a fuel issue and I took off the fuel tank and noticed a bunch of rust/dirt inside. I cleaned it the best I could and took the carb off and it had stuff inside and a clogged jet so I cleaned it, put on a new fuel line, and added a fuel filter after realizing it hadn’t had one in over 5 years. After that I changed over to super (fuel) and noticed it had less power. I ran it like that and kept adjusting the air/fuel.

The Problem:

One day I was riding in like 95% humidity (wasn’t quite raining but it felt like it was) and I parked it and turned it off. It took about an hour of cranking and sitting till it ran. Later that day it did the same thing except it would start. I noticed I had spark but it would ignite the fuel then just spin. 

I got it home and had been trying to find the problem when I noticed I no longer had spark. 

What I tried:

I tested the stator, replaced the spark plug wire/coil. Replaced the CDI box with a known working one. Replaced the spark plug. Also I noticed the positive to the battery had two wires going to it and tied together (see picture below) was butchered. I cut the wire off and cleaned the connection and put the wire on its own connection and attached it to the battery. After all this I still have so spark. 

Aditional notes:

I have had problems with the NGK plug not working after the first use in the past.

Also when I tested the wires from the CDI I noticed it would spike on the multimeter when I released the starter button. I took apart the CDI in my diagnosis and noticed brown rust looking stuff all over it. I cleaned it and put it back on. 

I also tested the battery and it is at 12.5V

2A18A889-EF35-42E8-86EC-4708567EEED1.jpeg

8E667B68-9633-4A78-9F1B-EF8F7E6205FC.jpeg

Edited by Aidan

Share this post


Link to post
Share on other sites


First try a new spark plug if you have had similar problems with that before. Next thing I would do is to verify that any safety switches (neutral relay etc.) if equipped, are working. Check the spots in the wire harness that ground to the frame, clean the grounds. Kill switch working properly? Ignition switch working? Lots of things to check as always lol. Good-luck and keep us updated.

  • Like 1

Share this post


Link to post
Share on other sites

I did disconnect the main kill switch and it changed nothing. I noticed one ground looked pretty rusted. I attempted to take it off but snapped the bolt in half in the process. I moved it to another spot that worked. I will check everything else when I can. 

Share this post


Link to post
Share on other sites

Replace the cdi. If there was brown stuff in it. I bet it's fried. Cdi's usually aren't ment to be worked on or taken apart.

Sent from my SM-N920V using Tapatalk

Share this post


Link to post
Share on other sites
15 minutes ago, 06kfx440 said:

Replace the cdi. If there was brown stuff in it. I bet it's fried. Cdi's usually aren't ment to be worked on or taken apart.

Sent from my SM-N920V using Tapatalk
 

I’m not talking about the actual cdi box computer. I’m talking about this (see pic)

if that’s what your referring to then sorry I  misunderstood. 

C8C37F74-AA00-41F7-8328-3DEC18C07C79.jpeg

Share this post


Link to post
Share on other sites


The voltage spike that you see is the draw on the battery when the engine is cranking. 

My guess is the pick up coil is prob on its way out. And since you have to open that cover up to replace it I would replace the stator coil as well.  Especially If you replaced the cdi with a known working one and it didn’t correct the problem.  Have a look at the rectifier ad well.   

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Forum Topics

    • By mike13ortega
      hey i recently bought a 1988 honda fourtrax trx300 2wd that dosnt run, it has no spark when i tryied kickstarting it the neutral light comes right up so i thought it may have some spark but checked it with the sparkplug against the frame and electric starting it and NO SPARK!!! so i dont know what might be wrong, i checked all the wiring and it all looks good, i put my honda recon coil it it and still no spark so im left with maybe a bad cdi??? or what else could it be??? any help please
    • By Todd Trask
      Well, I received stator, pick and new key switch asembly. I have great spark. Thanks to all whom responded.
      NOW it Starts up with hesitation. Idles good , give a little gas it boggs down, back fires & dies instantly. Will start up after it back fires
      DID I MESS WITH TIMING
    • By Frisbie6
      This is a strange question maybe.  I just finished cleaning my old barn find Suzuki.  I think it's a 1985.  LT230 shaft drive.  Started it up and other than making some carb adjustments (well, I think that's all I have to do) it runs fine.
      But as I drove it around the yard I noticed that it is hard to steer.  The front tires seem like they are barely touching the ground!  The handle bar moves fine and the wheels turn, but the tires don't grip the grass.
      When I lean forward as far as I can the tires actually bite into the grass and turn the bike.  When I sit on the bike it just plows straight ahead.
      Has anyone seem anything like this? 
      I wonder if the back tires are too small, causing the bike to lean backwards.  Does anyone have the specs on what size tires I should have?
      Thanks for any help provided...
    • By Rob113
      Hello guys! I ride a triton 450 super moto. i hawe change connecting road... Now all is okey,test drive ok manny km done. But there is one problem...i hawe buy a new accu. But the starter is verry hard rotate...almost stops.  So the motor is wery hard to start. I hawe trie connect the starter directley to accu and its the same thing.Before rebuild the starter has work normal.
      What hawe i done wrong?
      Sorry for my English:)
    • By StolenATV
      OUR TOY HAULER WAS STOLEN WITH ALL OF OUR TOYS IN IT. JUST HAD DIRT BIKES SERVICES.
      The post Stolen Black and White 2006 Honda Dirt Bike appeared first on Stolen 911.
      View the full article
    • By ron755
      I have a 94 Yamaha Timberwolf 250 4x4. I have no fire to the ignition switch, no nutral light, head lights, or tail light I can jump across the selinoid and start it. I put on a new solinoid. The neutral light comes on,while running, but dims when you give it throttle.
      Would this be a relay, not letting fire go to the key switch? If so, could someone post diagram from a manual, on how to test the relays?
      Thanks for any help
      Ron
  • Recently Browsing   0 members

    No registered users viewing this page.


×