Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Mark Walters

1991 Honda Fourtrax 300 no lights, no start

Recommended Posts

Hi guys.  First post, hope you can help.  As above 1991 Honda fourtrax.  Starting, running fine until a few weeks ago. Used primarily to put my ski boat in the garage (put 2" ball on front).  Any way, had just backed boat into garage, turned off to crank trailer wheel down, when I went to restart got nothing.  

No neutral light, no headlights, no reverse light, would not turn over when start button pushed.  It would crank and run when I jumped the contacts on the start relay.  While running the neutral light will come on, although it is dim and flickers.  Reverse light on when running and in reverse.

What I have done to this point:

1.  Used jumper cable to ground battery (-) terminal to engine block thinking ground wire from battery to engine may be bad.  No neutral light, no start.

2. Applied 12 volts to start relay.  Got a loud click like it was making contact.  I didn't have the battery/starter cables connected to the relay, but I am assuming it would have cranked at that time.  

3. Disconnected neutral switch wire.  Grounded neutral switch wire with jumper wire. No neutral light, no electric start. 

At this point I am thinking ignition switch vs broken wire in the harness going to the neutral switch (due to dimness and flickering when running).

Any and all suggestions to help track down this issue are appreciated.

Thanks

 

Edited by Mark Walters
Spelling, left something out

Share this post


Link to post
Share on other sites


Welcome to Quadcrazy, I would check the rectifier and see what’s going on. It’s possible that it’s bad causing a voltage issue. 

Then I would check the voltage at the battery and see what you have there including cranking if you can get it to crank. You may be right on a bad ignition.

Double check the the ground cable(black) where it bolts up to the frame from the wire coming off the battery. 

Wiggle the key also while this is going on to see if it starts.  If so then while it’s running wiggle the key to see if it acts up again.  

 

 

Share this post


Link to post
Share on other sites

Thanks for the response.  After spending some time studying the wiring diagram, I realized that I had missed one of the first things I should have checked.  The pair of fuses coming of from the battery.  Both fuses were good, but one of the connector wires had broken away from the fuse.  I used a jumper wire from the battery side of the fuse to the broken wire and the neutral light came on and it fired right up.

Now to find the wire to fuse connector to repair the broken one.

Thanks again.

 

fuse cable.JPG

  • Like 1

Share this post


Link to post
Share on other sites

That’s a good find ! Nice work, that’s an old type in line fuse.   I would order the newer style and splice it right in.  

I use these and they work great just make sure you put the right size fuse in.  You can see the amperage of the old glass  fuse on the metal part.     

Waterproof car fuse holder 5/10/15/20/30A Amp In Line Blade Fuse Holder with 10 pcs fuse https://www.amazon.com/dp/B01DLUQ1BW/ref=cm_sw_r_cp_api_i_9KhhDbSWH2JTZ

Share this post


Link to post
Share on other sites

funny how we usually think something wrong is buried deep within a bike thats making it not run right and all the time it was right under our nose..  happens to me all the time..  check the little stuff first i guess...

Share this post


Link to post
Share on other sites


Hello, i have a honda 300 1997 model so one day i was cruising down my road with all of my lights working then i started to see them get very bright then all of a sudden no lights the oil light came on and i instantly turned off the atv, after a few minutes of sitting i turned over the key and the oil light would come on then turn off after a few seconds but i have no neutral light the reverse light works and the oil light but no other lights work also the four wheeler will turn over off of the battery and at first i noticed after the incident happened when i would rev the engine the oil light would get bright kind of like a water hose being turned up but until this day i have no lights but the oil light when key is first turned on and the reverse light no other lights work. And to keep it in mind it was pitch black outside when it happened so i had alot of fun getting back home.

Share this post


Link to post
Share on other sites

Nothing like riding in the dark.  

Have you checked your battery and gone over any wiring that could have shorted out? 

Check all the fuses as well.  It could be your regulator or stator coil. But start with the basic stuff first and go from there.  

Share this post


Link to post
Share on other sites

It is most likely a rectifier/ regulator  problem.  It is possible  when  the rectifier /regulator goes  for the AC voltage  from the stator  to  spike up to  30 volts or possibly  more  and burn out your lights.  "Lights  going  really  bright  and then  off"  points to that possibility.  Check  your  headlight  by  jumpering 12v directly to the contacts on it. Check voltage  to the  battery terminals with the motor  running

  • Like 1

Share this post


Link to post
Share on other sites


I have the same problem checked all wires to fuses but starter button doesn’t work no lights come on getting no spark but motor turns over if I jump cylanoid but no spark it worked fine one day next day nothing some one give me an idea

 

Share this post


Link to post
Share on other sites

Locate and try to expose the ignition switch. You will need access at the back of the switch or the plug going to it. 
Check the ignition switch for power. One of the wires going to the switch will have 12+. Then turn the switch on and see if its sending 12+ out to the rest of the controls.  
If so that portion is ok. The next thing to check would be your neutral safety switch. It may be locking out your dash controls etc.  

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By stymy68
      Hello All,
      I have multiple Yamaha Timberwolfs, and I'm rebuilding a 92. I would like to replace the Ball Joints on the control arms. Does anyone know where I can purchase them? I don't want to purchase entire control arm. Ebay only has upper ball joints (Funny I don't see Upper Ball Joints, I have struts) and Cheap Cycle Parts, Partzilla and others don't even show the part number for the lower ball joint. There has to be something out there, these are just pressed in ball joints with castle nut and cotter pin.
      Please help cross reference. I have another Timberwolf I want to rebuild.
    • By Michael Kastanis
      Hey I have a Kawasaki 300 boyu and it die in 5 gear and can’t get in Neutral try rocking it and moved it back and forth but nothing can same one here help me pls

    • By John Victor
      My father-in-law gave my boy a 1999 350 Big Bear. It's been sitting in a barn for a bunch of years. It runs great! My boy has been riding a couple weeks now and it has developed a squeal coming from the front end when you get off the gas at speed. No noise during acceleration. At first I thought brakes. I took it for a ride and I don't think it is the brakes. I feel it is the front prop shaft U-joints, front differential or one/both axles. I pulled the fill plug on the differential and I can't find anywhere how much gear oil should be in there. My gut says up to the fill opening. It doesn't have a manual. It's wet in there, just don't see any gear oil.

      #1 Should I fill the differential with gear oil up to the fill opening?

      #2 How do I check or know if the u-joints are bad? That looks like a "Big Bear" of a job if they don't need to be replaced.

      #3 What else could it be? I don't think it is the front bearings. I jacked the front wheels off ground and no play in the right wheel. Very little play in the left wheel, looks like the lower control bushing is where that play is coming from. The rubber CV boots look original but all still intact. Wheels spin easily without any noise.

      Thanks for any help!
    • By Randy1951
      Quad starts fine and revs fine in my back yard. On a test ride it falters badly. No power. I have cleaned and rebuilt the carb, cleaned the fuel tank, installed new fuel filter, changed fuel line and cleaned the air filter. Any help would be appreciated.
  • Similar Tagged Content

    • By Chase Cook
      Hi I was riding my Honda the other day and I gave it gas for about a quarter-mile just flooring it and then it started to lose power. I pushed it about a mile home which was a pain in the butt but when I got home It still had gas, compression and spark. Do you think the timing jumped possibly?
    • By goldenroot
      View File 2005-2006 Honda TRX500FE/FM/TM Fourtrax Foreman Service Manual
      Manual  covers the following models:
      2005 Honda TRX500TM FourTrax Foreman

      2005 Honda TRX500FM FourTrax Foreman

      2005 Honda TRX500FE FourTrax Foreman 4X4 ES

      2006 Honda TRX500TM FourTrax Foreman

      2006 Honda TRX500FM FourTrax Foreman

      2006 Honda TRX500FE FourTrax Foreman 4X4 ES

      Submitter goldenroot Submitted 04/19/2020 Category Honda ATV  
    • By goldenroot
      Manual  covers the following models:
      2005 Honda TRX500TM FourTrax Foreman

      2005 Honda TRX500FM FourTrax Foreman

      2005 Honda TRX500FE FourTrax Foreman 4X4 ES

      2006 Honda TRX500TM FourTrax Foreman

      2006 Honda TRX500FM FourTrax Foreman

      2006 Honda TRX500FE FourTrax Foreman 4X4 ES

    • By Arnold Schimberg
      Hi Guys
      I have 88 4trax FW , it has a booster circuit
      In the cdi control fed from a leg in the alternator. 
      MY Honda service manual says you will get no spark without this circuit on this model. 
      Can someone explain a little about this please ?    Thanks
    • By Guythis448
      Looking for help on wiring up stock wiring harness specifically for a '88 Honda TRX 300 
      If anyone could drop a link or send me a PM it would be much appreciated 
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...