Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Ryan Geiler
New to the ATV world, picked up a solid used Kodiak 400. It appears the former owner did some sort of modification for a saddle bag or something along those lines--and I'd like to match it up and replace it. Not a big deal by any means but something I thought I would give a shot at finding.
does anyone recognize what kind of luggage/bag/cargo would go where those white tabs are he drilled through that fuel fender?
By mike costa
Motor starts right up, but when I open it up past quarter throttle it bogs way down while ridding, the longer it runs the worse it gets. If I just leave it in neutral and give it full throttle it revs up and down.
Bike sat for 3 years,
Installed new plug, cleaned the fuel tank, took it to a shop and had the carburetor gone though.
Picked up from shop, motor bogged down first day and barely got me back to the truck an 1 mph.
Took back to shop after a month I was told it had a bad plug, I told him I just replaced it.
Got quad home and it is doing the same thing!!!!!!!!!
Thanks in advance for your support!
The carburetor has recently been gone through by a shop
Let me start with I have about 30 years of ATC experience, but not much with stuff made after 1988. Some, but I'm mechanically inclined so it's all good. I"m rehabbing a 1997 Bayou 220 to send back into the wild and the mechanicals are now all good, just working on making the electrical system...electric. Right now, I have no power on the white wire as tested directly on the plug at the starter solenoid. I'm assuming that wire is supposed to be hot any time it's attached to a battery? The genius that had it before snipped a couple wires and inserted a fairly heavy push button for electric start bypassing the electrical system. I think i've corrected everything north of the solenoid but the white wire has me stumped. Is my assumption that this should always be hot with a hot battery correct? Does this indicate a broken circuit in the starter solenoid? Relay was also bad and wired incorrectly, but that's resolved and I can make the relay click bypassing the solenoid and connector, directly giving the white wire 12V. Thoughts?
Recently Browsing 0 members
No registered users viewing this page.