Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
Figured I'd share the wealth with my over 35GB library of shop manuals. Enjoy, and everyone have a very Merry Christmas!
2005-2009 Honda TRX400EX/400X
2000-2003 Honda Rancher TRX350 TM TE FE FM
2000-2003 TRX350 TM TE FE FM service.pdf
2005-2006 Honda Foreman TRX500 FE FM TM
Honda TRX500FE FM TM Foreman.pdf
1988-1994 Honda TRX300 Fourtrax, 88, 90-94 TRX300FW Fourtrax 4x4
1995-2000 Honda TRX300 Fourtrax TRX300FW Fourtrax 4x4
1985-1986 Honda TRX125 Fourtrax 125
1995-2003 Honda Foreman TRX400FW Fourtrax
HondaTrx_400fw_Foreman Service Manual 95-03.pdf
2003 Honda Rincon TRX650FA
1997-2004 Honda TRX250TE/TM Fourtrax Recon
Thats a good starter kit...post up your requests in this thread, I have tons more...Hope this helps.
I was riding my 400ex one day and when i shut it off to put it in the garage i tried to start it put again to drive it into the garge and it wouldnt start.I put a compression tester on it and its like 30 psi with out throttle and 0 psi WITH THROTTLE.
when i put my finger over the hole it fell likes its pulling my finger in more then its pushing it out
Has good spark.When i took it into the shop the said it had 1oz of oil in it and a tiny pit of metal shaving(TINY BIT LIKE 30 flakes)
When i try to pull start (push start/roll start) it made a not normal sound and wouldnt stay running.
If my bottom end is blow why would it still turn over fine,
Are my valves siezed or not working properly
or is my timing off causeing valves to not open in correct order with fire
PLEASE HELP all help is appreciated
By Mark Walters
Hi guys. First post, hope you can help. As above 1991 Honda fourtrax. Starting, running fine until a few weeks ago. Used primarily to put my ski boat in the garage (put 2" ball on front). Any way, had just backed boat into garage, turned off to crank trailer wheel down, when I went to restart got nothing.
No neutral light, no headlights, no reverse light, would not turn over when start button pushed. It would crank and run when I jumped the contacts on the start relay. While running the neutral light will come on, although it is dim and flickers. Reverse light on when running and in reverse.
What I have done to this point:
1. Used jumper cable to ground battery (-) terminal to engine block thinking ground wire from battery to engine may be bad. No neutral light, no start.
2. Applied 12 volts to start relay. Got a loud click like it was making contact. I didn't have the battery/starter cables connected to the relay, but I am assuming it would have cranked at that time.
3. Disconnected neutral switch wire. Grounded neutral switch wire with jumper wire. No neutral light, no electric start.
At this point I am thinking ignition switch vs broken wire in the harness going to the neutral switch (due to dimness and flickering when running).
Any and all suggestions to help track down this issue are appreciated.
By Richard Barlup
I have a honda trx200 and it starts fine when I use the starter button but won't start with the pull cord.
Recently Browsing 0 members
No registered users viewing this page.