Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

T_bell40

1989 Warrior 350 Carburetor

Recommended Posts

Question: Do you have to take gas tank off to get carburetor off the quad. ?? 

It's gummed up again and needs cleaning. Put Sea foam in tank hoping it would dissolve any crud. No joy

Share this post


Link to post
Share on other sites


You don't have to take the tank off.  Sometimes it makes life easier but it should be able to come off without taking the tank off.  I like to loosen both clamps first.   Disconnect the gas lone, pull the carb out so you can take the throttle cable and the choke cable off.  Re assemble in the same way.   

Share this post


Link to post
Share on other sites

Ok. Sounds good. 

I seen something about loosen clamps and turn to take bottom off float to change out jet.  Would that be enough to get out what's gumming it up. ??

Any videos you know of ??

Thanks for your reply

Share this post


Link to post
Share on other sites

Honestly heres my take.  If its at the point where you feel its bad and a possibility that the  tank my have skunk gas as well then pull the tank and clean the carburetor and tank properly.   I've very rarely had luck by rotating and cleaning the carburetor in place.  You only wind up pulling it all out again. 

  • Like 1

Share this post


Link to post
Share on other sites


@T_bell40 I like to take the bolts out if the airbox so it will push back a bit, helps me get the carb out easier. Waste of time to try to clean without removing IMO

  • Like 1

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By bodon
      Anyone know what the fuse terminal marked UNSWITCH  does  .  Even with the key off it is causing a drain on my battery and I'm trying to figure out  what that terminal goes to.  It's a 10 amp fuse. If I pull it the "short" goes away.  Thanks in advance.
    • By Dra O
      posted a while back - it was running at one point - I have all the plastic shroud off - it's down to frame and engine now
      -fuel pump: when line from petcock is attached, no fuel comes out other side to carb; the line to the carb is open (can blow through it); I thought when I cranked engine that the pump would spit out fuel on other side but it does not; I removed fuel pump and opened it up - diaphragm looks good - but internal areas had lotsa calcification build up - I cleaned this out and dried it good - the clear plastic pieces (?diaphragms) aren't broken - the spring w/ steel ball on end moves freely; am putting it back on tomorrow; but can anyone answer about the pump? isn't it supposed to pump fuel through it... to other side... to carb? puzzling
      -along with fuel pump: I replaced petcock 3 weeks ago (gas tank had rusty fuel in bottom - cleaned it out prior to new petcock); when I turn petcock arrow NOT to on or reserve, fuel comes out of line; when I turn it to on or reserve, fuel doesn't come out; puzzling
      -I don't know what's on back of fuel pump - it's a valve that has a hose coming out of it - looks like it goes to engine/carb - I haven't traced this out yet - what is it?
      -can squirt gas on air filter and engine will run for 2-3 seconds then stop - fuel in top of carb (under diaphragm) does same
      -it likely needs carb rebuild - will get to this - but something isn't allowing fuel to get from fuel pump to carb
      -I THINK it has a mikuni model x carb - diaphragm is ID 26mm  OD 68mm - hard to find inexpensive diaphragm, I guess because it's a model x
      -last thing - I replaced solenoid due to old one clicking; I HAVE to be charging the battery or it won't start/turn over - battery just goes dead; but if charging, it'll turn over nicely; i'm guessing it's a bad battery
      -any help appreciated - I've never owned an ATV before - inherited this beast from grandparent in-law
    • By Ed Zeppeli
      Hi,
      Oddly I'm having  a hard time ordering front brake shoes for my '98. 
      I'd appreciate recommendations on decent, widely available shoes if possible. Ideally available in Canada on short notice.
       
      Thanks much,
       
      Warren
    • By Rich1028
      Leota Quad Trails  on New to us  Machines 5-10-20
      We Just Picked up two Quads Friday,and we took them out riding,great machines!
      2008 Honda 400 Ex and a 2014 Honda 400 X

       
       
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...