Quantcast
Jump to content

What Hauls your Toys and Why????


Recommended Posts

I bought this trailer a few years ago for $200 and rebuilt and repainted it and i only have a little over $600 in the whole trailer... its an 18ft with 3500lb axles and brakes on one...

trailerweb4.jpg

My jeep with both of my bikes ready to go riding... It pulls ok but after i get my rock buggy done i will have to get a bigger trailer and a truck... Im going to start looking for a Duramax after i graduate in december...

DSCN2828.jpg

Here is my buddies gooseneck that we took to waynoka last year... doubles as a huge tend... Worked awesome...

DSCN2584.jpg

Link to comment
Share on other sites

  • 9 months later...
I bought this trailer a few years ago for $200 and rebuilt and repainted it and i only have a little over $600 in the whole trailer... its an 18ft with 3500lb axles and brakes on one...

trailerweb4.jpg

My jeep with both of my bikes ready to go riding... It pulls ok but after i get my rock buggy done i will have to get a bigger trailer and a truck... Im going to start looking for a Duramax after i graduate in december...

DSCN2828.jpg

Here is my buddies gooseneck that we took to waynoka last year... doubles as a huge tend... Worked awesome...

DSCN2584.jpg

That is awesome great find on that trailer for $200 you did some good work I wish I could find a deal like that.

Good looking Jeep too.

Link to comment
Share on other sites

  • 2 months later...

This is my toy hauler. I don't have a pic of the trailer. But I have a 2 place snowmobile trailer. Works really nice for ATVs LOL

This is a 2000 Xterra. It has 3.5'' of lift, 33s, and tons and tons of mods. I bought it all rusty and I completely restored it and I am loving it to death. Its my daily driver gets decent gas mileage and is as fun off road as my quad.

IMG_0191.jpg

Link to comment
Share on other sites

  • 5 weeks later...
  • 9 months later...
  • 1 month later...

I've gotta figure my situation out as I'm just getting my atv. Haven't had to haul it yet. Probably the smallest possible trailer that it will fit, pulled by my old POS 4cyl ranger. Wish i could just load it in the bed, but it's a step side. Widest part of the bed is 42" and trx450r = 46" :(

Link to comment
Share on other sites

LilRaRa you should be able to fit your quad in the step side. I used to put my old banshee in the step side. Just the outside of the front rims would roll over the wheel well and then fit perfectly. there was plenty of room once it was over the wheel wells. and I know that you can lay a 4x8 sheet of ply wood in that bed laying on top of the wheel wells. So I would give it a try and see but I bet if fits. Might be tight but should fit.

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Charlesbrown
      I’m looking for a top end kit for a Yamaha. I would like to see how well the engine runs before spending $6-$7 hundred on oem. Niche has complete kits from $1-$2 hundred.  Anyone have experience with Niche or similar Chinese companies? 
    • By DrtyGrlKristin
      Just thought I'd start a new thread for newbies to the site!
      If you're new here, tell us who you are, where you're from and what you ride!!!
      Lets get to know each other a little better shall we?
      I'm not new to the site, obviously, but...
      I'm Kristin from Denver!!! I ride a 2008 Yamaha Rhino. She's my muddy baby!!!!!! Several aftermarket parts on her. She's good to me! We try and ride every weekend. This weekend we're off to MOAB! :woot:
    • By DarkRider
      This is something I'm extremely curious about. Has anyone ever attempted to buy a quad (or any other vehicle) from an impound lot? I've always wondered if this could be a bargain, or a waste of time. Google searches do turn up some helpful results. Looks like the state of NJ holds auctions online which I'd be a bit hesitant about.
       
      My online searches haven't really turned up any results of anyone buying an ATV this way. I'd be really curious if anyone tried this, or knows someone who has. I've actually found a couple pages with online auctions for my state, but none had ATVs.
    • By p5200
      Hello, what is the best method for installing bearings into their race? I've set one in place and tapped it down until it was metal on metal. Is that sufficient? Surely it's not supposed to go into the race until flush? Also. does the coil spring on the seal go into carrier bearing housing not facing out? Thanks! 🙂 Seal goes in until flush correct?
    • By Mikey69
      Heres my story. Kinda long. I guess I was a late bloomer when it comes to quads. I had never ridden a quad in my life. Rode Dirt Bikes as a kid growing up. Back in Oct of '06 I found a Mustang on craigslist. Took it for a test drive one morning before work. Fast car. 351 Cleveland. I had planned on meeting the guy again after work. For some strange reason thats still to this day beyond me, I stopped in Hillsboro MotoSports on the way home from work. I had 6 Grand on me. There was a left over '05 sitting by the front door. It was on sale for $4999. It was $5499 OTD. I didnt even look at anything else. I knew nothing about quads accept I thought it really looked coool and I had the money in my pocket to buy it. I was sitting on it when the salesman walked up and asked... "Can I help you?" Without hestitation I pulled 60 Ben Franklins outta my front pocket and said "I want this Quad. Load it up in my truck." It was just about dark by the time I drove away from the shop. BTW, I didnt bother to ask my ol lady if I could buy it. LOL. Anyway, I took it by the house and showed her. She was kinda stunned but not mad. We drove over to a friend of mines house and unloaded it. I took it to the field across the street from his house. HOLY CHIT!!!!! I was surprised by the power. I had it for about 2 weeks and took it to Sand Lake. I was there a few hours and rolled it on a banked turn at the top of the bowl right before you get to the one-ways. When it rolled, I flew off and landed on my belly. The quad came bouncing and landed on my back. For a month I couldnt even walk. I was scared of it. I considered trading it for a 250EX. Went back to the shop. The salesman said..."Dude!!! You dont want a 250EX!!! Trust me. Just get used to it" I still wasnt convinced. I put it on craigslist for $4000. Calls were coming in. I had a guy that wanted to come look at it that evening. I decided to take it for one last ride at Browns Camp before I sold it. I was still afraid of it. After about 5 minutes I started feeling comfortable on it again. I decided right then, I loved my Honda 450 and would learn how to ride it instead of selling it. That was late Nov of '06. Work was slow for a Painter in Oregon. My new job everyday? Going to Browns Camp and ridding my Quad. I bought my Girl Friend an '02 Blaster. I rode my 450 for 4-6 hours almost every single day for 3 months. And yes, I know my way around Browns Camp pretty well. LOL. In March I bought her an '06 TRX250EX (Thank God I didnt trade my 450 for one of those) LOL Since then, I have become totally addicted to quads. I love them. Couldnt imagine not owning at least one quad. Luckily I have two. My "07 was $6500 OTD in July of '07. Bought it for my Girlfriend. Traded in her 250 EX. A month later we broke up. So, I wound up with two Honda 450's.
       
×
×
  • Create New...