Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Christian Brindle
I have a 2000 Polaris Sportsman 500. A year or so ago we got it running after replacing the kill switch. It ran great but after some use for a couple months it got a flat tire and for some reason we just forgot about it and it sat for some time. Before it sat i replaced the gas cap, fuel filter, fuel pump, petcock, battery, starter relay, oil and oil filter. I recently went to start it and it started so quickly and without choke or throttle but the ATV wouldn't move till about 1/4 throttle and it wasn't really a smooth ride until 1/2 throttle. it also would bog out randomly after you came to a stop and sounded like it was getting too much fuel. I cleaned the carb and adjusted the air/fuel screw to 1 3/4 turns out. I also messed with the idle and the throttle cable adjuster up on the handlebars. It's safe to say it now runs worse than when i started working on it 2 days ago. It takes more effort to get started and bogs out idling after about 30 seconds. I tried adjusting the idle but every time i do it'll get to a sweet spot but after driving it down the driveway and back the idle will go up and down to the point where i can't put it in gear because the gears will grind. Any thoughts or ideas would be greatly appreciated. Thanks
Want to show you one automotive show that I filmed in my town called Crazy Race. This was two day race in Qualifications round, Semifinals and Final. In this 4 parts I am showing best moments from all rounds and entertainment of the show.
Crazy Race Part 2 contains a qualifying round where all riders race against each other, selected by lot and split by two. They are free to drive in any direction and to hit their opponent's car everywhere except at the driver's door. Anyone who intentionally hit the other car in the driver's door is disqualified. Winner of each race continue in the semifinal round. In this part I will present the best moments of the qualifying round!
Part 3 shows you the best moments from Day 2 - Semifinals and Final. Battles in the semifinals are among the winners of the first day races, but this time they are selected by lot and divided into 4 battles of 4-5 cars each. The rules in each battle are that they only have to drive in one direction and try to neutralize other opponents until there are only two players left. Then the battle between the two last drivers has the rule to drive in any direction until only one who has qualified for the final round is left. Again, anyone who intentionally hit the other car in the driver's door is disqualified.
For the final round there were only two cars left, because the other two players who got the right to be there had problems with their car and could not participate.
Part 4 containing entertainments between battles and winners rewarding.
This event will have second round in 05-06 October 2019 and also will be filmed For this new round I will filmed in many new angels and places. Will prepare a lot more videos and many new entertainments . This 4 videos was my first try so many things to wish for better filming in the future one.
Hope you will like them and of course feel free to comment and to ask everything. Hope you will Subscribe to my channel and to be first to see my other content and of course new round of Crazy Race! Thanks!
So my parents have not let me get my license yet and I need to get around to gets parts and stuff. Answer: Yamaha CW50 scooter. This is a 2-cycle self-mixing scooter that so far, I am really surprised with the power output and speed. It reaches about 45mph since the speedo has been disconnected and has plenty of power for two riders. Its stupid looking, but with some work and a title and plate, it'll take me around town.. My issue is this: No key. I bought it for $150 from a friend and he bought it from someone for $100 who wired in a switch in place of the ignition. That guy got it form his neighbor who's renter left it behind. The scooter will run with this switch on or off (kill switch on handlebar kills engine) To get it tiled and a plate so its road worthy, I need to get the ignition working either by a replacement key or a new ignition. All wires are cut to the ignition and the switch turned on the power to the signal light switch. Also, the 2-cycle oil was leaking out the carb, through the air filter and onto the scooter. also, it runs great, but its making blue smoke with throttle and the muffler is wet with oil.
(I have new signal lights for it btw) So the issues I have with it summed up:
No key (need new ignition) smokes burnt out headlight- can I replace them with LEDs?
By james p
Hey all new member so I'm sorry if this isn't the correct place to post, but I'm having trouble with a 2000 polaris magnum 500 I just acquired. The quad ran when I got it but was having problems that sounded like the camshaft, and sure enough camshaft lobe was pretty much gone, so we replaced the camshaft and exhaust rockers and now the quad doesnt have spark. We had the quad running right before we tore the old camshaft out and now no spark. Anybody else ever have a problem similar? We've been checking for loose wires, checked grounds, and double checked timing but cant get it figured out so any advice would be appreciated! Thanks
By Cj Winds
I have a 2000 Polaris Xplorer with the 250 two stroke motor
It does not want to start with the electric start, the motor cranks fast, the battery is good, and there is good spark when cranking. The engine starts perfect when using the pull cord, it even starts if I pull the cord slowly and starts with one pull. The engine idles smoothly once started. My wife says she needs the electric start to work.
Similar Tagged Content
By Christian Brindle
I've already posted here once about this ATV. Lots of people suggested i check the cam and after a couple months i finally got around to attacking it. I got it all apart and got the cam/rockers out. I'm almost positive they need to be replaced, they're pretty scored up and don't look too hot. Just wanted some final opinions before i drop the money on it. I'll also take feedback on the new cam i've chosen.
New Cam: https://www.amazon.com/hz/wishlist/ls/2GM2J05FQQPCD?ref_=wl_share
i have a 2000 suzuki king quad lt-f300f that i picked up as a project bike. it didnt run well when it was parked outside 5 years ago. it cranked after putting fresh gas - but would not run below half throttle, i took apart the carb, cleaned debris, and re-assembled. i suspect that the pilot needle is sheared off - it never protrudes into the throttle body through the pinhole. now to get the bike to ALMOST idle, the throttle idle adjustment knob is all the way up/in. the pilot needle is turned almost all the way in/up (if i understand correct, it should nominally be out 2 1/4 turns or so). and like i said, it will ALMOST idle. floods easily, rides rough.
wanted to hear from those more experienced than me with suzukis - and im self-taught atv repair, so dont laugh too hard if my verbiage/part names is way off.
facing the driver's side of the bike [US] there are three hoses on this side of the carb. without a service manual or way of knowing what was messed up before i got it, i think i have them right: front hose as a vacuum to the petcock, middle hose as vacuum to the fuel pump, rear hose as fuel line from the fuel pump. running the bike in prime position results in flooding even while riding. with all hoses disconnected from the carb, fuel slowly drips from the vacuum line connected to the petcock.
so just my speculation is that the diaphragm in the petcock is split, and the pilot needle is broke off - causing my inability to not quite idle and the rough ride. this suzuki is hoses and cables everywhere compared to the honda ranchers and yamaha warriors i am used to. I would like to have a plan rather than: replace everything at once.
is my speculation on the right track, or could something else be at play? say, if the compression was non-existent, would that cause non-idling? i am all ears, look forward to the input.
I traded my dirt bike for a 2000 arctic cat 500 semi automatic. when i went to go pick it up the guy said it didn't get spark, so i thought it was going to be something simple like a coil. well it wasn't. first thing i did was take all the plastics off to get easy asses to every thing. so i bought a brand new battery for it seeing if it got power, it didn't. the dash wouldn't light up neither would the lights, so then i tried to see if the starter worked it didn't so i jumped the solenoid and the starter started turning over the motor. so i bought a new starter solenoid, when i installed it the electric start still wouldn't work , so i bought a new kill switch and starter switch that goes on the handle bars, when i installed it, the electric start still wouldn't work. so then i went to see if i could get spark by pull starting it, i didn't get any spark, so i bought a new spark plug, and guess what, still no spark, so then i bought a new coil for it to see if that would fix it. so i installed the new coil and guess what no spark still and still no power to the dash. so to sum it up i'm not getting any power any where to the four wheeler. so i cleaned all the leads and plugs and still nothing. so then yesterday i took the wiring apart to see if their was any frayed wires, and no their wasn't. does any one have any ideas what this could be i'm up for anything. also if any one knows how to bypass all the wiring just to get it to start i open to that to, or if someone knows where i can get a wiring diagram.
i have recently purchased a yamaha kodiak ultramatic 400cc. it is used and sat outside for a long time. i have done a lot of work on it and got it to run sort of. when i try to start it, it will start and run for a little bit then it will die, the time it runs varies. it has a new cdi, spark plug, and stator. most of the time it wont even start it just cranks over. there was one time that it started up right away and ran perfectly but the next time i tryed it wouldnt start. before that one time every time it started and ran it had a popping sound. i cant figure out why it wont run. any help would be muchly appreciated! thanks!
I'm new to this site and to CanAm/Bombardier atv's. I purchased this quad local to my area and shortly after started noticing a knocking noise from the bottom end, which I've been told may need a rebuild.
The atv is complete, but I'm now looking to part it out, unless someone knows where I can get the bottom end rebuilt for a decent price.
I can take some pics of the quad and upload. If you need parts off of it, let me know and make me an offer.
Recently Browsing 0 members
No registered users viewing this page.