Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

mikeexplorer

2007 Arctic Cat 700 EFI 4x4 Wiring Diagram

Recommended Posts



Wiring diagram for 2007 Arctic Cat 700 EFI 4x4

do you suppose the wiring diagram for a 2008 is the same as 2007?

Share this post


Link to post
Share on other sites

need help got 2008 700 4x4 two problems 1 the dash keeps flashing volts put in a new battery still got the problem and 2 the steering when i take off it pulls hard to the left can any bodytell me what might be the problem with these problems

thanks

Share this post


Link to post
Share on other sites


i have read that if you disconnect the multipin to the pod display, clean it, and dielectric grease it, that may solve it.

if you can raise the rear of the bike, rotate the wheels separately, if you dont have resistance on the left one, you might have an axle/cv joint problem ...

hopefully an A/C guy will jump in ...

Share this post


Link to post
Share on other sites

you need to check the connector from your stator. they are very prone to failure! the connector melts and causes a short. this connector is of poor design. as for the pulling to the side your caliper may be seizing or a very bad wheel bearing. i dont know the history of your machine so its hard to tell

Share this post


Link to post
Share on other sites

also you need to check battery voltage (at the battery)when your machine is running. should be 13.8-14.2volts constantly even when rpms are increased.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By ray desocio
      Anyone have a legible service manual for a Dinli diamond back 50cc? The one on Dinli’s website is a scanned in copy and the wiring diagram is totally unreadable. Got some issues I can’t seem to figure out. I think that Polaris used the same platform these years 2001 ish?
       
      any and all help would be appreciated 
    • By Colin Davis
      I recently acquired a Yamaha bear tracker 250 that does have a wiring harness.  Does anybody have a wiring diagram for the 250s. Also if you have a pin diagram that tells be the colors of the wires going to the cdi and rectifier or just a picture of the plugs would be much appreciated. I can’t find anything on the harness online. I have all of the switches and stuff and I plan on just build a harness myself because I can’t find one to buy.



    • By Devin Hazelwood
      I have a problem finding a wiring harness for this particular ATV. Does anyone know were I can get one or were I can get one that's from a different name but similar harnesses?
    • By Samo121
      Hi everyone, 1st time posting, I’ve got a gy6 quad Chinese one I think wording was all cut up so decided to replace buying a new loon off the net. Problem I’m having is stator wiring not sure how to wire it up as all different colours? Please see photos any advice would be really appreciated thank you .



  • Similar Tagged Content

    • By Joseph Miller
      Hi guys im new here and ive been doing alot of research on my polaris predator i was wondering if anyone on here has wired a different cdi up on there quad? Not a direct replacement that would simply just plug in. I know my white an w/red wires go to my pulsar my green an blue go to my reverse coil but im unsure which is + and which is ground also brown/w is a ground correct? What about purple? Black goes to my kill switch and red is my 12v supply........then ive got yelloww/red , yellow / yellow that goes to my rectifier..........any input on this subject is greatly appreciated thank you all
    • By Michael Aiken
      Where can I find a wiring diagram for my 2005 450 Kodiak. Thanks.
    • By Andrew Baker
      I need help with wiring on a 1998 (I think, 10th digit of the VIN was W) Bayou. I'm not getting spark, I'm pretty sure it is due to grounds being off because the harness is pretty hacked as far as the electric start and charging system goes. I'm needing a good wiring schematic. I found one online and there are a few things that don't add up on it so I'm skeptical that it is really for my year and model. Any help would be appreciated. Thanks. 
       
    • By Larry Fox
      Has anyone had any luck putting a different gauge on this machine. Would you happen to have the wiring diagram? 
    • By davefrombc
      View File 1999 Polaris Magnum 500 Wiring Diagram
      Wiring diagram for 1999 Polaris 500Magnum
      Submitter davefrombc Submitted 09/08/2019 Category Polaris ATV  
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...