Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
My lakota has a new carb and just had a top end redone by a professional, but it will not start. The electric start turns it over great, there seems to be compression. It seems like its trying to start, getting right there and just doesnt catch. It does start occasionally, but wont run for more than a couple of minutes and smells rich. Im assuming the carb needs to be tuned, but im just wondering if anyone else has any ideas before i get a chance to work on it.
By Ed Zeppeli
I picked up this quad after the previous owner couldn't get it going.
The issue is that I can't get it to fire at idle or at all.
- replaced plug. Decent blue spark. Also tested with spark tester inline.
- rebuilt the carb. PO had already bypassed vacuum lines from petcock. There's fuel at the cylinder
- Checked compression with new gauge. reads 190 psi
- cleaned all contacts I could access.
- am currently jumping with car battery. Solenoid jumpered.
- checked cam timing at TDC and adjusted valve lash
- put gas directly into cylinder to see if it will fire at least momentarily
Motor turns over well. Plug gets wet.
Motor may fire once or twice but smokes through exhaust a bit as if it's trying to fire or combusting.
This leads me to suspect timing. As mentioned I checked the flywheel mark versus cam marks. Perhaps someone has been in there before because I can't find a 'T' on the flywheel but there is a very visible paint mark which aligns with TDC position on piston. Possibly a slipped flywheel/woodruff?
Is it possible that if it had seen previous repairs, that the timing could still be off? I'm reluctant to dig into the flywheel/stator area if there's something else I could have missed but all signs point me to that area. Would a bad CDI cause spark timing to be off?
Anywhere else to diagnose incorrect spark timing?
I've scoured these forums and elsewhere but I'm posting just in case there's something I've overlooked up until now.
Thanks very much for reading!
By Chad Dickerson
I am goin nuts here! I have a 04 400 air cooled 4x4 , I'm a atv,car,truck,mower mechanic for yrs,just sayin. Ok it cranks and kinda fires now and again then after 5 min of cranking and stopping itl start if u touch throttle itl did then u start all over! If u let it warm up sumtimes u can throttle it up other times it just does! Just depends on it? When it stays running it runs awesome,no problems except it just does randomly like u shut key off? Sumtimes itl start right back up others itl do the no start thing! IV put new plug,adjusted valves and hot tanked carb? I'm at a loss here guys! Please any other ideas? I don't think it's anything to do with flywheel? It's not the auto it has a hi low reverse lever on left fender and foot shifter? Help please lol
i know this isnt an atv but same type of thing. I have a riding mower im fixing and selling for my aunt and it has a dead battery. i jumped it off my atv and when i turn the key nothing at all happens. i tried jumping the relay still nothing. this is with the seat down. you wouldnt think this mower would have issues as its a top-of-the-line brand and almost brand new (aunt found it for a good price, still got tits on tires, just sat for a couple months in a mechanic shop
Similar Tagged Content
Problem: The ATV starts and runs at idle perfectly. But as soon as I open the throttle, the engine starts to slow down until it stops. On the attached video you can hear the sound of how it works: see video below
Prehistory: there is a Polaris Sportsman 500 1998, which for about 1.5 years stood in repair, including also replacing CDI with one taken from the same ATV. Finally, the vehicles were on wheels, traveled several kilometers and overheated - forgot to fill the antifreeze Came back home in small moves. The next trip started well, but after 10 km there was a feeling of a small drop in power (even as the vehicle got warm completely) but still drives. Next trip - the situation is repeated. The next test of ATV through time and a huge loss of power from the very beginning. The engine sneezes, does not want to go more than 5 mph.
What has been done: the carburetor has been replaced with a new one (inexpensive, $ 40), a new spark plug, a new ignition coil, the engine head has been removed, the piston is in good condition, valves were corrected - but the problem was definitely not in them.
Ignition control unit is suspected. Who faced similar? Please help in solving the problem.
Thanks in advance.
I am having an issue where it sounds like the gears are slipping if I hit the throttle really hard and also after letting off when the engine brake is applied. Also, the drive train that goes to the front also rides again the gear shift box. I will attach pictures and a video here shortly.
Thanks in advance!
Recently Browsing 0 members
No registered users viewing this page.