Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
Sadly this may be the last post I make on the old '11 Crown Vic (320k). So yesterday I heard a quiet hiss coming from the front which turned out to be a very small radiator leak...in the middle of a fin somewhere. Doing errands around town today I kept extra coolant with me and added it as it needed. After filling it up I make a 60 mph trip to a nearby city about 20 miles away. When I get to a stop at the bottom of the off ramp, I hit the gas it it doesn't move. No extra lights on the dash except for the check engine light which was already on for something else. I put it in park and back in drive, tried all the gears but got nothing, not even in reverse. Thinking it might have something to do with my coolant situation I checked it and ended up putting in like 1.5 gal of coolant which is much more than it's taken before. Only thing I can imagine is that the leak got worse on the interstate and I didn't notice it. Did the no coolant issue cause the transmission to overheat somehow? There was a slight burning smell in the cabin so something definitely overheated. The overheat light on the dash never came on (I think I have one?) and the engine ran fine the whole time. I was traveling at 60 mph though so I wonder if that would be enough to cool the engine off while the transmission still overheated?
What in the heck happened and what do I do, besides sell the damn thing.
I got this 400, that wouldn't start. It would try, but wouldn't catch. I checked the valves and the L intake was tight at .002. The compression came in around 120. It didn't improve after a couple of drops of oil into the cylinder. So,I figured it was the valve causing the problem. So, I got the valves squared away, but it still won't start. I checked the spark and it seems like it's getting an intermittent spark. It fires a few times then nothing. If l let up on the button and then hit again immediately, it will fire a few more times, then repeat. So, what am I looking at as a possibility? Electrical issues are not my strong point. LOL
I am in need of a manual for my KLF 300 Bayou 4x2 . I've found others on here for the 4x4 model, but was wondering if I need a separate 4x2 manual. Does anyone know?
these are what i have in my collection ... always looking for more
1985 - 1990 Suzuki LT230 & LT250 Service Manual
1987 - 1998 Suzuki Quad Runner 250 & King Quad 280 Service Manual
1987 - 2006 Suzuki LT80 Service Manual
1987 Suzuki LT500R Quadzilla Service Manual
1988 - 1992 Suzuki LT250R Porting Instruction
1988 - 1992 Suzuki LT250R Quadracer Service Manual
1988 - 1992 Suzuki LT250R Tuning Guide Instruction
1999 - 2004 Suzuki King Quad 300 Service Manual
2002 - 2007 Suzuki 500LTA Service Manual
2002 - 2009 Suzuki LTF250 Ozark Service Manual
2003 Suzuki LTZ400 Service Manual
2006 Suzuki 50LTZ Quad Sport Service Manual
2004 Suzuki 250LTZ Quad Sport Service Manual
2005 Suzuki LTA700 King Quad Service Manual
2007 Suzuki 90LTZ Quad Sport Service Manual
2008 Suzuki 400FLTF King Quad Service Manual
2008 Suzuki 750 King Quad Service Manual
2009 Suzuki 400LTZ Quad Sport Service Manual
ALSO CHECK SUZUKI ATV SERVICE MANUAL DOWNLOADS
By Dra O
posted a while back - it was running at one point - I have all the plastic shroud off - it's down to frame and engine now
-fuel pump: when line from petcock is attached, no fuel comes out other side to carb; the line to the carb is open (can blow through it); I thought when I cranked engine that the pump would spit out fuel on other side but it does not; I removed fuel pump and opened it up - diaphragm looks good - but internal areas had lotsa calcification build up - I cleaned this out and dried it good - the clear plastic pieces (?diaphragms) aren't broken - the spring w/ steel ball on end moves freely; am putting it back on tomorrow; but can anyone answer about the pump? isn't it supposed to pump fuel through it... to other side... to carb? puzzling
-along with fuel pump: I replaced petcock 3 weeks ago (gas tank had rusty fuel in bottom - cleaned it out prior to new petcock); when I turn petcock arrow NOT to on or reserve, fuel comes out of line; when I turn it to on or reserve, fuel doesn't come out; puzzling
-I don't know what's on back of fuel pump - it's a valve that has a hose coming out of it - looks like it goes to engine/carb - I haven't traced this out yet - what is it?
-can squirt gas on air filter and engine will run for 2-3 seconds then stop - fuel in top of carb (under diaphragm) does same
-it likely needs carb rebuild - will get to this - but something isn't allowing fuel to get from fuel pump to carb
-I THINK it has a mikuni model x carb - diaphragm is ID 26mm OD 68mm - hard to find inexpensive diaphragm, I guess because it's a model x
-last thing - I replaced solenoid due to old one clicking; I HAVE to be charging the battery or it won't start/turn over - battery just goes dead; but if charging, it'll turn over nicely; i'm guessing it's a bad battery
-any help appreciated - I've never owned an ATV before - inherited this beast from grandparent in-law
Similar Tagged Content
What’s up fellows I am looking for some heads for z400 motors or the whole motors themselves. Also I am looking for Keihin FCR carburetors in 39mm and or preferably the 41mm is what I would prefer. The newer the better I hate to price a new casting of that head from the dealer. Please hit me back in the thread or pm me if you can help me. I need to build a motor to beat a Banshee. All offers will be considered. Thanks for your attention in the matter. Peace.
I went out to ride my quad today. When I started it up it ran for a minute, then died. Since then it will turn over but won't start. I've check the spark plug and get great fire. I have had this quad for about 6 months, and very new to breaking it down. But need help. Thanks
Took my wolvy for her first trail ride past weekend. Got home and cleaned all the mud and dirt off. Went to take a spin around the neighborhood and started having issues.
When you are about 1/2 to 3/4 throttle the RPMs will sudden spike way up with little difference in power to the machine. Once you shift to the next gear it will increase power/rpm consistently then same thing happens and you get a sudden RPM spike. It also seems to recreate the problem if you are low in the gear and try to punch it...High rpm with no power increase. If you shift gears and gradually increase throttle she will increase power and RPMs consistently but if you shift and are more than 1/2 throttle it will increase power and RPMs fine until you get about 1/2 to 3/4 way through the gear then you get the same RPM spike...
Hope I am explaining this clearly. My truck did a similar thing once and it turned out to be a whole new tranny...hope this is a different issue. Thanks for your help guys and gals.
Ok i got a 1991 polaris trail boss 350 i bought from my neighbor and he didn't know what was wrong with it here the piston skirt broke off and dropped in the bottom end i ripped motor out and ripped it apart to get the pieces out and everything looks good so i put it back together it needed a key so i bought a new one well it didn't work so i bought one off a junk wheeler and it worked but wont shut it off i revs up so what could be causing this.
And my transmission dont have high range what made this happen?
Recently Browsing 0 members
No registered users viewing this page.