Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

ninhalo5

1999 Kawasaki Lakota 300 stalling problem.

Recommended Posts

Curious what is the main function of the stator?

I hooked an ohm meter to mine and the values are off from what is noted in the Clymer book.

I am having some running issues with the bike but it's not too bad, mainly the bike does not like steep hills The hill it refuses to climb is (on a clock between 1-2 o'clock) it'll go about 1/2 way and lose all power. on the other had the hill next to it varies between 1-3 o'clock and is a little bit of a longer ride I can climb that with no problem.

other than that after the bike has been rode for awhile say an hour or so I get some (but not always ) hesitation and slight backfiring in gears 1 & 2 every thing runs smooth in gears 3-5

I started checking all of my electrical system and so far the stator is the only thing with mismatched numbers. I have not tried the rectifier test yet for I don't have 3 12v batteries to run the test.

The only thing I can figure that is wrong with the bike possibly causing my power loss is from the stator, but without knowing what it's actual purpose is, I can't say that for sure.

Thanks

BTW. the bike in question is a 99 lakota

Share this post


Link to post
Share on other sites


Ok thank you, well I guess if the primary function is an alternator then any issues I have must be coming from elsewhere... Time to rip apart the carb :D

Share this post


Link to post
Share on other sites

I renamed the thread. I think that you will likely find your problem in the carb, I think your float might not be adjusted properly.

Edited by DirtDemon

Share this post


Link to post
Share on other sites

Thanks DD, though the bike never really stalls, it just loses all its mojo. kinda acts like it's back in neutral when climbing a real steep hill.

I tore the carb apart lastnight and hit an issue, someone torqued the crap outta one of the jets and I can not get it out, I forget which one it is; pilot jet I believe. It's the jet that where are three jets side by side this is the one that the head of it is way down in the hole.

does anyone happen to have a tip on how I can free this brass jet without destroying my carb?

Thanks

Share this post


Link to post
Share on other sites


When you say it's like it is going into neutral, do you mean the motor is still running ok and the power isn't getting to the wheels, or the motor just loses power? If the head strips off, try soaking it in PB Blaster or something similar, drill the hole out enough to get a small easy out in there. Before you try to extract the jet, try giving it a sharp tap on the top with a small screw driver and a hammer, hopefully that will help shock the threads loose and help with the removal.

Share this post


Link to post
Share on other sites

Thanks, I was a little hesitant in using an extractor on a brass jet :)

Any ways I went ahead and placed the carb in some boiling water and ran a thin copper wire through the jet to make sure it wasn't clogged, interesting enough when I removed the diaphragm there was 2 springs in there, looking closer to it the orig spring looked like it was cut there was a perfect line up on both ends.

Oh the joys of used items lol

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Billy Aldrich
      2001 Honda foreman 450s manual shift. i can shift through the gears when the ATV is off, but when I turn it on, I can shift into first, but I cannot shift to second or even back to neutral. Same with reverse. I can get it into reverse but cannot shift out. If i turn it off it will shift back fine, any idea? I just bought this and fear I got screwed over. 
    • By LOGAN WARNER
      Hello everyone, I’m new to this forum. I have a 98 king quad 300, I cannot get it to run right. It will start up and run for a little bit but then it starts sputtering when you give it throttle. It appears to me that it is getting to much fuel. 
      this is what I have done to it: new carburetor, new fuel filter, adjusted the valves.
    • By Amboyjim
      Having serious problems with quad it completely stopped running on me took carb off and tore apart cleaned everything put back on and it started idled but when driving it had no power at all so took carb back off and noticed their was a puddle of gas and oil in the bottom of the air filter box and also their was gas in the vacuum line HELP
    • By jimsvtx
      I'm working on my brothers' 2002 Suzuki Vinson 500 . It sat for a few years before I got into it. I'm concentrating on the carb - I replaced orings, needle, etc. and soaked jets, bowl and anything that I could get off the carb that the solution wouldn't eat. I also removed the tank and flushed it with hot water - it's clean. The gas cap innards rusted away and the tank had a lot of rust and water in it before I cleaned it. I replaced the gas cap and installed a new fuel valve because the screens were broken in the old one. The bike will run but spits and sputters and backfires. If you "open it up" it falls on its face and stalls - but starts right up. Here is a link to an exploded view of the carb: Ohio Honda Yamaha Motorcycle ATV Dealer - J & J Motors - Kawasaki Suzuki Scooter Utility vehicle, parts, accessories, apparel
      Can anyone point me in the direction of the problem? It may still be a "clean carb parts issue" . My problem is that the parts list doesn't identify the parts to a degree that I understand. If you said" look at the pilot jet", I'm not sure which jet that would be....See what I mean? It'll run very good if I remove the air filter and cover the opening with my hand and part my fingers a little for the air to get in. Any help is greatly appreciated.
      Thanks in advance, Jim
  • Similar Tagged Content

    • By pizzaman_288
      How hard is it to change the outer seals on the rear differential mine are leaking fluid and I have no idea on how to change them out any help would be great thanks
    • By katasha2
      I took apart the carburator to clean out and I can't remember exactly where the springs that are inside the float are supposed to go I've tried to look up schematics but I think I am missing a spring maybe need helpt:confused::confused:
    • By kingjosk12
      A week ago I could not even get close to starting it. But now I adjusted the valves (exhaust valve was not closed). i got it running but would not run without choke. i adjusted the float because it was to low tried starting it up again and it would not even start. So i went back and looked at the valves and the valve was now open again so i adjusted it and it started right up and ran perfect without choke. So i put it all back together thinking it was ready to go. Started it up and let it run for a little bit. i turned it off and tried starting it again there was NOTHING. took it apart and there was 0 compression and the exhaust valve was open again. I am completely lost need help PLEASE!!!:aargh:
    • By ut1w7b
      I have a 94 sportsman 400. It sat for several years before i got it. I have cleaned the carb it will start and run for about 5 min then it will flood. I have torn it down and cant see anything wrong. has anyone else ran into this problem any hel would be great.
    • By calebjasonkarl
      SID, know as seaisound, Our Motorcycle are directed from Japan
      With the Complete International manufacturer Warranty
      We ship only to the valid address
      For security reasons, we are unable to alter the address or redirect the motorcycle after payment has been made
      1 How much does it cost to deliver this to my location ?
      Its 200usd to deliver to any local buyer. 300usd to International buyer
      2 How long does the shipment takes ?
      Delivery time to a Local buyers takes three days. seven days to International
      3 What about the motorcycle registration documents ?
      The registration documents would be ship along with the motorcycle
      Contact us
      info {at} seaisound . com
      site www . seaisound .com
      Kawasaki Super sport Bikes
      2015 Kawasaki Ninja H2R New $44,099
      2015 Kawasaki Ninja H2 New $20,099
      2015 Kawasaki Ninja ZX14R ABS 30th Anniversary New $10,099
      2015 Kawasaki Ninja ZX-10R ABS 30th Anniversary New $9,099
      2015 Kawasaki Ninja ZX-10R ABS New $9,099
      2015 Kawasaki Ninja ZX-14R ABS New $8,800
      2015 Kawasaki Ninja ZX-10R 30th Anniversary New $8,800
      2015 Kawasaki Ninja ZX-10R New $8,800
      2015 Kawasaki Ninja ZX-6R ABS 30th Anniversary New $7,700
      2015 Kawasaki Ninja ZX-6R ABS New $7,500
      2015 Kawasaki Ninja ZX-6R 30th Anniversary New $6,900
      2015 Kawasaki Ninja ZX-6R New $6,700
      Kawasaki Super sport Touring Bike
      2015 Kawasaki Concours 14 ABS New $10,099
      Kawasaki Sport Bikes
      2015 Kawasaki Ninja 1000 ABS New $6,900
      2015 Kawasaki Z1000 ABS New $6,900
      2015 Kawasaki Ninja 650 ABS New $4,500
      2015 Kawasaki Ninja 650 New $4000
      2015 Kawasaki Ninja 300 ABS New $2,500
      2015 Kawasaki Ninja 300 SE New $2,300
      2015 Kawasaki Ninja 300 New $2,200
      Kawasaki Versys Bikes
      2015 Kawasaki Versys 1000 LT New $7,799
      2015 Kawasaki Versys 650 LT New $5,600
      2015 Kawasaki Versys 650 ABS New $4,900
      Kawasaki Touring Bikes
      2015 Kawasaki Vulcan 1700 Voyager ABS New $14,099
      2015 Kawasaki Vulcan 900 Classic LT New $4990
      Kawasaki Cruisers Bikes
      2015 Kawasaki Vulcan 1700 Vaquero ABS New $14,099
      2015 Kawasaki Vulcan 900 Custom New $5,499
      2015 Kawasaki Vulcan 900 Classic New $5,199
      2015 Kawasaki Vulcan S ABS New $4,099
      2015 Kawasaki Vulcan S New $3,999
      Kawasaki Off Road Bikes
      2015 Kawasaki KLX140L New $2,099
      2015 Kawasaki KLX140 New $1,999
      2015 Kawasaki KLX110L New $1,800
      2015 Kawasaki KLX110 New $1,500
      2015 Kawasaki KX450F New $5,099
      2015 Kawasaki KX250F New $3,999
      2015 Kawasaki KX100 New $2,200
      2015 Kawasaki KX85 New $2,300
      2015 Kawasaki KX65 New $2,199
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...