Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

dirtjunkie85

Kawasaki KFX 450R Intake

Recommended Posts

Got my FCI intake today cant wait to put it on and see what kind of power gains it gives, if anyone is familer with this install and knows any tips let me know, I image it wont be to bad.

Share this post


Link to post
Share on other sites


take off all your plastics it'll help alot, be careful with the air sensor on the intake they're known for breaking while removing and re-installing them. It'll also be a good time to double check all the clamps on the intake from the throttle body back making sure there's no tears or other leaks.

Share this post


Link to post
Share on other sites

Turned out not to be to bad it is a pretty tight fit but that is a good thing the only thing I dont like about it is everytime you need to clean your filter you have to pull your rear fender and air box but it is worth the power increase, I took it out this week end and it was awesome until I lost all power and the motor started makeing a heck of a nosie rattle and knock I am going to make a new post to see if anyone has any ideas but as far as the intake goes It is pretty sweet now I just got to get my quad running again so I can enjoy it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Chris Owens
      I have an 04 arctic cat 400 fis 4x4 manual changed the centrifugal clutch,  changed the clutch discs and adjusted the clutch. When shifted into gear forward or reverse it will leap a little but will not go it was moving with the old centrifugal clutch but it was worn out. Any help would be appriciated 
    • By Michael France
      I have a Kawasaki Bayou 220 KLF220A and I cannot get it to start using the starter button. I have replaced the starter solenoid and the starter relay. I have followed the wiring diagram in the repair manual and it looks like the switch is working well, the neutral and reverse relay have power running through them and appear tp be working correctly. However, I can not find a wire runnng the the starter button that has power on it. Anybody have any idea what the break down is?
    • By Daniel Gibson
      Working on a bayou 220 that has been ran extremely hard it's whole life. Literally had almost an inch thick dirt/oil covering the motor. Yeah that bad. Surprisingly it runs though. I cleaned the carb and tank multiple times. They're clean enough to eat off of. Readjusted valve lash and set timing. Was about 3 teeth off. It cranks good and runs good only problem is I have to cover the carb intake basically choking the hell out of it for it to start. The com choke works fine. It does this each time I start it regardless of temperature both ambient or motor. Wth? Compression is at 115psi I get 130s if I put a little oil in the piston chamber. Please help. Thanks 
    • By wendi loden
      I replaced the fuel pump filter and it ran great for a week or so. Then while driving across the yard in 3rd gear it shut off and hasn't started since. It has fire and its getting fuel, all fuses are good, battery fully charged. The fuel pump relay seems to be warmer than it should be when spinning it over. Any help is appreciated!
    • By Shane Pillar
      Talk about what kind of atv you have and what you do with it.
  • Similar Tagged Content

    • By Xyla Cat
      View File 2008 Kawasaki KFX 450R Service Manual
      2008 Kawasaki KFX 450R Service Manual
      Submitter Xyla Cat Submitted 08/25/2018 Category Kawasaki ATV  
    • By Xyla Cat
      2008 Kawasaki KFX 450R Service Manual
    • By 2 fast 4 u
      So i recently bought a Honda TRX 450r 05 kick start model i am the 3rd owner. this bike ripped when it was running but i ceased it.I freed up the piston but there is little compression now. i think i ran it out of oil but it was like 20hrs or so since the last oil change. My real question is that i heard you have to rebuild the top end every 15 hours is this true? Now i have bought a new big bore kit to replace the cylinder and the piston but i dont really want to have to rebuild it every 15hrs.
    • By schmeck
      Anyone know of a good repair besides replacement for the ever cracking Big Bear 350 intakes. Replaced with a Zoom Zoom about two operational hours ago and the new one is cracked.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...