Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By Dan Ellsweig
I have a 98 Polaris Magnum 425. Runs GREAT for 10 minutes then starts to load up (sounds rich) and looses power. Final;ly just stalls out on idle. If it sits 20 minutes will run again.
replaced fuel, added fuel treatment (seafoam), Replaced plug (carbon fouled), plug wires, air and fuel filter, checked all fuel and vac hoses, REPLACED carb with new. Still no good. Just ordered a coil, not sure if that will help
Note: both the new and old carb only had the idel adjuster screw - cant find the jet adjustments or air/fuel mix screws so I cannot say how they are set.
Looking for ideas short of spending big $$ on Polaris service
By LOGAN WARNER
Hello everyone, I’m new to this forum. I have a 98 king quad 300, I cannot get it to run right. It will start up and run for a little bit but then it starts sputtering when you give it throttle. It appears to me that it is getting to much fuel.
this is what I have done to it: new carburetor, new fuel filter, adjusted the valves.
I have a gentleman that asked me to service his bayou for him. I have always wondered what oil should be used in atv engines? Pros? Cons? What weight should be used in what type of weather? Is there one kind that I could bulk buy and safely used in any quad I worked on or owned? What about performance? Engine Life? This has always been a 🤔🤔🤔 area for me with quads as far as why you would use one type of oil over another....
Recently Browsing 0 members
No registered users viewing this page.