Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Recommended Posts

A lot of you know I had to buy a nonrunning quad to get a replacement frame for my prairie 650. I paid 300.00 today I sold all the left over parts for 200.00 The stuff was worth more than that I'm sure but at the same time I don't have too part it out and wait for buyers and shipping no ads no calls to deal with & I get all the stuff out of my way and get that part of my garage back.

Share this post


Link to post
Share on other sites


I am sure the new frame is worh 100bucks. Hope you are back up and running soon.

Share this post


Link to post
Share on other sites

If you recall I had a bad front diff that was going to cost 400.00 for parts only so I got that taken care of too. Most frames were 300 on ebay I bought a whole quad minus plastics.

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Hellraiser69
      Just got a new to me, 99 Kodiak w/ plow and an extra set of tires for dirt cheap. I'm curious where you guys purchase your parts for your older ATV's? Google is great to find parts, but I'm hoping you guys have some stores, online, that you prefer on a recommendation basis. I've already purchased my tune-up items, but the brakes need some work and I'll likely end up having to replace the steering stem bearing, front CV axles and a few other things down the road.
    • By Rick Shropshire
      Happy New Year all! Remember not to operate any vehicles while under the influence, you could get busted or worse, you could get hurt or hurt someone else who's playing it safe and end up in jail. Have fun and be safe.
    • By Randel1
      I am trying to put a 1994 Suzuki 250 quadrunner back into service. I have it up and running like new but need to replace the plastics as they are brittle and crumbling due to age and sun exposure. I would like to purchase new parts either OEM or aftermarket but have had little luck in finding them. I would even consider used or salvaged parts in serviceable condition. Any help in locating these parts would be greatly appreciated. Thanks in advance.
    • By MarkinAR
      So just as a general FYI, it might be good to check replacement parts before installing.  If possible, check clearances with a micrometer before going through the trouble of assembly.  I say this as I bought a new driveshaft yoke for a Kodiak because the ujoint dropped a cap and got the yoke in a bind...blowing the yoke and middle drive gear to shreds.  So I replaced the middle drive gear and bought a new yoke and ujoint kit from Caltric.  Caltric is usually pretty solid replacement parts.  The new yoke however was a good 4mm too narrow for inside lock ujoint caps.  Disappointing since it came as a kit from Caltric.
      Ended up taking an angle grinder to the new yoke and thinning material off to get it to the needed 41.25mm opening size.  Sucks having to disassemble everything again and start over but my fault for trusting replacement parts.  Nearly 40 years of turning wrenches and I made a rookie mistake.
    • By technofarmer
      Well its finally happened, its time to replace the belt on my 2011 Polaris Sportsman 500 H.O.   Is there anything specific i need to know before getting into it? Is there one brand of belt i should get over another?   I'm still on my first Polaris and plan to keep it at least another 8 years.   
  • Similar Tagged Content

  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...