Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

AAicone

2007 Arctic Cat 700 No Spark

Recommended Posts

my arctic cat 700 has fuel, and air but no spark.... i was riding it one day n it backed fired n shut down on me tired to start it up again n she wouldnt start... i waited a couple days she started right up ran for 5 minutes then shut down again... now she wont start at all any suggestions?

Share this post


Link to post
Share on other sites


Check and make sure you have power to the Coil and spark plug also check your key switch is working correctly. Change out the spark plug and see if that helps.

It may be a short under the rear plastics or near the front handlebars where they go through the black plastic.

Other common problems for the 07 are the magnets on the flywheel and the starter.

Take a look at the wiring first and let us know what you find.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Dan Ellsweig
      Greetings
      I have a 98 Polaris Magnum 425. Runs GREAT for 10 minutes then starts to load up (sounds rich) and looses power. Final;ly just stalls out on idle. If it sits 20 minutes will run again.

      replaced fuel, added fuel treatment (seafoam), Replaced plug (carbon fouled), plug wires, air and fuel filter, checked all fuel and vac hoses, REPLACED carb with new. Still no good. Just ordered a coil, not sure if that will help
      Note: both the new and old carb only had the idel adjuster screw - cant find the jet adjustments or air/fuel mix screws so I cannot say how they are set.

      Looking for ideas short of spending big $$ on Polaris service

      HELP?????

      Thanks

      Dan
    • By Steven Urban
      First time using this forum.  Owned a Kawasaki dirt bike once, had no issues.  But I picked up this 4 wheeler at an auction.  They stated it ran, but only needed a battery.  Well I do not believe that was all true.

      Some pictures are attached.  Not sure why, but the whole air filter stuff was removed.  They had some small thing inserted as a make shift air filter.

      I purchased a battery to try this all out.  Waiting to return it and get the proper size, as it was too big for the battery box.  But here is my issue I had while the battery was connected.

      1 - The lights on the steering column did not come on.  Not sure if they work or not.

      2 - The starter solenoid seems to be bad.  I have a new one on order. 

      3 - In the pick, there is another rusted part.  Not sure what that part is or what it is used for.

      4 - What is the 12v rectifier?  square bodied part.

      So when I hooked the battery up.  Pushing the start button did nothing.  Pulling the cord to try and pull start, it turned, but would never fire.  I have put in a new spark plug as well, it looked worn out.  With electric start, I crossed over the posts on the start solenoid, it turned over, but would never fire and start.

      I have read a few other threads and it stated something about needed the neutral light on.  SOmething about a kill switch.

      Any help would be appreciated.



    • By Jack.hart
      Need help with a 2007 polaris phoenix 200 no spark new cdi,new ignition coil,checked resistance on pulse coil and stator,not getting power to start button now guessing the solenoide went in all the testing not sure.also have three ground wires to battery is this normal or..?
    • By Rigo Mena
      I have a Kawasaki bayou 220 that won’t start I don’t know if it has something to do with the electrical wires but when I put the screwdriver on both bolts of the relay it wants to crank but can’t and there’s a missing piece I think it’s another relay that has 6 wires going into it
  • Similar Tagged Content

    • By mikeexplorer
      Wiring diagram for 2007 Arctic Cat 700 EFI 4x4
       
       
    • By Admin
      2007 Arctic Cat 700 EFI 4x4 Wiring Diagram
    • By Admin
      View File 2007 Arctic Cat 700 EFI 4x4 Wiring Diagram
      2007 Arctic Cat 700 EFI 4x4 Wiring Diagram
      Submitter Admin Submitted 06/29/2019 Category Arctic Cat ATV  
    • By x
      It's time to replace the shocks and struts.  Looking for some stiffer springs than the OEM as I use this for farm work and I put heavy loads on the rear and haul small trailers frequently.  I've seen a couple aftermarket offerings that say they're 10% or so heavier duty.  Any other options for something a little stronger / stiffer?  Thanks.
    • By LMI
      The saga of the fan continues.
      The Pin attempt in the fan shaft failed.  I then moved on to trying to weld the fan hub to the fan shaft.  I took it for a run the weld broke.  Now it was truly F'ed.  To recap the dealer price, they want $400 + CND for a replacement fan assembly.
      I searched all sorts of after market places and no one carried one.  Ebay had some used ones but they were $120 USD + Conversion rate for something as old as what I have.  I went to Amazon and eventually settled on this.
       
      amazon link
       
      What I found... and was amazed... was that the fan mounted to the Suzuki fan assembly bracket.  I was prepared to manufacture my own mount conversions...  It also came with "Harpoon mounts" (nylon zip tie like things that go straight through the rad.   Anyways it mounted to the original bracket. It fit perfectly.  Cut the electrical plug off replaced it with the Suzuki... all good.  Let the quad heat up, thermo coupler kicked in the fan circuit, polarity was right... all was good....  Fan is under the circuit fuse rating.  
       
      so I finally have a solid fan solution.  $34 CND vs $400+ CND
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...