Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

pmnova

Best place to buy cvt belt

Recommended Posts

My sons 2005 Brute Force 705i needs a new belt and im looking for recommendations for good places to buy a cvt belt from also is there any special tols needed?

Share this post


Link to post
Share on other sites


I came across your post here so I thought I would research the belt. We run CVT mini quads so I understand about the belts. But noticed that nothing comes up for a 705i...I did see a 750 4x4i...I have never heard of your quad or know anything of it. Is a 705i rare? You might want to check with G-Force Powersports. They have so much for quads & more & the service/tech help is terrific. Ask for Amy or Gary. Heres the link: G-Force Powersports Wellington, FL 1-800-658-1843

and their phone number is: 1-800-658-1843. Maybe this can get you in the right direction.

Share this post


Link to post
Share on other sites
Sorry 750i 4x4

No problem...Ok found a few places to look into but depend on if its

BRUTE FORCE 750 4X4I (KVF750-A1)

BRUTE FORCE 750 4X4I (KVF750-B1)

1)2005 Kawasaki BRUTE FORCE 750 4X4I (KVF750-B1) Driven Converter/Drive Belt | CyclePartsNation Kawasaki Parts Nation

2)Kawasaki ATV/UTV CVT Drive Belt : Kawasaki : Brute Force : Brute Force Parts

3)Carlisle Drive Belts - Chaparral Motorsports

4)Kawasaki ATV Parts 2005 KVF750-A1 Brute Force 750 4x4i DRIVEN CONVERTER-DRIVE BELT Diagram

I do not know how reputable some of these companies are but im sure with a little research you can narrow down on price, reviews, belt specs, & more.

Hope this helps & Good Luck!

Share this post


Link to post
Share on other sites

Thanks MX, the dealer wanted $140. Looks like i could save alot of money going with an aftermarket belt but considering how hard my son rides the 750 im going with an OEM but not from my dealer. Thanks for the help

Share this post


Link to post
Share on other sites


Thanks MX, the dealer wanted $140. Looks like i could save alot of money going with an aftermarket belt but considering how hard my son rides the 750 im going with an OEM but not from my dealer. Thanks for the help

You’re welcome. Completely understand wanting OEM only. I think most of us would love to support our local motorcycle shops but when money is tight were forced to search for other avenues. Our race team is on a budget 365 days a year…lol :wink:

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By technofarmer
      Well its finally happened, its time to replace the belt on my 2011 Polaris Sportsman 500 H.O.   Is there anything specific i need to know before getting into it? Is there one brand of belt i should get over another?   I'm still on my first Polaris and plan to keep it at least another 8 years.   
    • By Barry Troxtell
      I have a 2005 Sportsman 500, Instrument cluster will not illuminate, hi/lo beams work though.  Any tips or troubleshooting info is greatly appreciated!
    • By barracuda420
      Hi, I'm new to ATV/UTV's and am looking for any advice that would help to repair my 2018 Ranger 500.  I got it from an insurance auction and have never owned one before.
      It looks like it was sunk deep.  Found rocks and sand in the roof, milky oil in the air filter box, water in the fuse box, etc.
      So far, I've cleaned the air box out, vacuumed most of the rocks and sand, checked the engine, trans and diff casings for cracks/leaks.
      The battery would not charge while connected so I know there is some short somewhere...probably the wet fuse box.
       
      I plan on drying out the fuse box and all connectors with a hairdryer tomorrow, check the fuses, remove/dry out the ECM and disassemble/clean the air intake.  Then install the battery and see if i can get it to key on and see what kind of lights I get.
      Need to know what to expect with the engine/trans...
      Thanks.
       
    • By Nate Hanson
      I am a new atv owner...I bought a used atv this summer (pretty sure it is a wolverine but reg card from last owner didnt actually say that so idk for sure). It ran great for most the summer and early fall but one day I tried starting it and it turned over a while without starting and then suddenly it quit turning over at all. No click or anything.
      I charged battery and light turns on showing neutral and heatlight can go on.
      A few other things that may be pertinent: The pull start is missing, I have a fluke multimeter but not many other advanced tools (or relevant experience), there is an extra aftermarket led light attached to front but it doesnt work either... never looked into why since I didnt need it. 
      I looked for a fuse box and didnt find one.
      Please recommend some easier things to try first as I really want to avoid taking it in if I can (having one income and 4 kids can keep out extra cash, plus I want to learn). Pictures would be awesome if possible. Thanks! 
    • By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
  • Similar Tagged Content

    • By technofarmer
      Well its finally happened, its time to replace the belt on my 2011 Polaris Sportsman 500 H.O.   Is there anything specific i need to know before getting into it? Is there one brand of belt i should get over another?   I'm still on my first Polaris and plan to keep it at least another 8 years.   
    • By Connie Johnson Donald Hudson
      Smells like gas in the oil ... Also, recently replaced belt, new BT does not have grooves on both sides, does that pose a problem?  Also just bought and replaced new carburetor, never has it idled better, but give it gas and it backfires very loudly!
    • By bodatiouskid
      Just bought a 2003 Kodiak 450.At take off,the belt doesnt grab for a few seconds.Is there any wat to tighten belt?& how tight should it be?
    • By toonces
      New to ATVing here and just got a '11 Grizz with the belt drive transmission and I've been suggested to take along an extra CVT belt along in remote rides just in case. I'm somewhat knowledgeable about where to get quality parts for cars but not so much for ATVs. Who makes the best CVT belt for my bike? Also, who makes just ok belts and who should I stay away from?
      Also, I'm looking at getting a snatch block for a synthetic rope winch and wondered if the type rope determines what type of block you should get...or are all snatch blocks the same and I'm just thinking about this one too much?
      Thanks
    • By Tim-ANC
      What is a good after market brand for CVT belts? Want durability and gripping power. Intended for a 2009 Suz King Quad 450.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...