Do you own an ATV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
I have had this ATV since new, and no work done on the system before. It has an intermittent issue with starting for years but getting worse. Cranks but no start or have to cycle power. No Codes. There are times it starts right up and then times it will not start at all.
What I have done, new plug, new battery, new coil. Also, the manual I have has spec info for the H1 & H2, but when I check ohms & AC voltage & wire color, it is more in line with the H2 than H1.
Ok here is what I have done.
1. new plug then new battery.
2. checked and replaced the coil- primary was 5ohms and secondary was 20.4K ohms. Since my book said for the H1 the Primary should be less than 1ohm I replaced (new one had the same 5ohms, confused! H2 says 4.8ohms). Book says secondary should be 12k-20k ohms and it was 20K ohms. New coil did not correct the issue.
3. Stator, AC output while running was good, about 75 volts AC no load between the three yellow wires (but mine are gray wires like the H2). Ohms were also less than 1 ohm.
4. Crankshaft position Sensor. Again, H1 should have Blue & White but I have Blue & Green like the H2. I have 180 ohms across the Blue & Green wires, so this is good. But when cranking I have 2 volts AC. For the H1 book says 5 volts AC. But H2 says 2 volts AC.
So, is my position sensor putting out low voltage or do I have the stator assy for an H2 in my H1 ATV from new? Stator & position sensor are one assy. Has this ever been an issue that was noted? New Stator is $$$ so I don’t want to just shotgun a part.
Any help would be great!
Hey I'm looking at purchasing a 2006 Arctic Cat 650 H1 SE but don't know much about Arctic cats, how reliable are they and will it make a good Mudder/work horse?
Here is a link to the one I'm looking at
Sent from my LM-Q910 using Tapatalk
By Steve Howard
Hey I was thinking about buying this 400 cheap The way it's smoking I think the cylinder will need bored? can this bored or re sleeved
By Bruce Madsen
Riding last week and the machine shut off, towed it back to camp and discovered that the ignition fuse was blown. Replaced the fuse and as soon as I hit the starter button it blows again. Is there any component that might cause the issue? I checked the wiring runs and could not find any wire breaks. Using multimeter I see a short on the orange wire from the fuse block.
Recently Browsing 0 members
No registered users viewing this page.