Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
I have a 2018 Kodiak 450 EPS that just this past Sunday I ran through a bit of water.
After the puddle the belt was slipping, so I pulled over and drained the ultramatic housing and the slipping problem went away. This was all in L and everything seemed to work fine. Later when I got on a road, I put it in H, but it still rode like it was in low... i.e. I had to rev it up a lot just to get to 30mph.
When at home I pulled the ultramatic cover off to inspect, and it looked okay in there. Not much dirt, belt and everything are clean, but when I rev up the engine (with cage in place, of course), the belt doesn't get to the top of the clutch (maxes out about an inch or 1.5" from top of clutch, so maybe it is normal).. I put it back together but same thing... H seems like L still.
Do you think the clutch needs to be further dissected for cleaning, or could this be an issue with the gear selector?
Had the problem earlier this month. Found the air intake filter (K&N) covered in mud and cleaned it. Took it out this weekend and it worked great until I went on a longer ride.
After it warms up, it bogs down at about 20mph. Engine sputters. No change at full throttle. It runs fine at lower RPM. Once it cools off, I can run it at higher speed for a few minutes then it bogs down. Seems like there is an electronic component that overheats. Check engine display comes on when it happens. Did manage to complete our 34 mile ride though.
Buddy suggested the throttle position sensor. Will dig into the manual later on.
By Ray Roberts
Hey everyone im new here, i have a problem with my 2001 suzuki quadrunner 500. When i start the bike up it sounds fine but a few seconds later the idle speed just keeps rising to where you cant put it in gear, and if im lucky it will climb down to where i can put it in gear but when i press the gas it immediately want to die. Please help me!
I have been working on a 2004 arctic cat 400 that will run for a while with a new coil installed then after a few min start sputtering and quit. Checking the coil afterward it it is burned up. There is 350 Plus volts going to the coil and I'm not sure if I need a CDI or its something else? Flywheel magnets have been ruled out!
Similar Tagged Content
By Connor Tuftin
I have a 1988 300 Honda FourTrax, All wheel drive.
My brother and I were fixing up this quad. We put a brand new battery and fuses in and it was running fine until we put the quad into reverse. As soon as it was put into reverse all of the electrical cut out and power wasn't making it to the head unit anymore and both of the brand new fuses popped. We figured there might have been a short from the starter or solenoids, but they are all working properly. At this point we don't know where to start looking for where the short could be. I'm just wondering if anybody has had the same issue or knows of similar issues that could cause these electrical shorts?
By Resurgence Small Engine Inc.
Not satisfied with the commercially available versions, Jonathan recently built an ATV spring compressor.
In this video, he demonstrates using it to remove & re-install the spring on an ATV coil-over shock absorber.
Mistake in video - the coil-over shock is not quite a McPherson strut.
If you are inspired to build your own spring compressor, feel welcome to use any ideas from this video.
Thanks for watching! Resurgence Small Engine Inc.
By Robert Ochoa
Don't worry about hauling the ATVs. We have the helmets, goggles, and gloves covered too. Our equipment is well maintained and gassed up ready to go!
We take the work out of your fun!
Book your next adventure now!
#fourwheeler #atvlife #atvriding #atv #4wheeling #fourwheeling #mudding #outdooradventure #atvs #mudlife #powersports #northcarolina #southcarolina #southcarolinalife #offroading #AwesomeATVRentals #yamaha
If you are looking for a used ATV for sale, where do you look? I know ebay and craigslist have used ATVs for sales and then sometimes you find local trade publications where they list used ATVs. I was looking online and decided to list out some websites that sell used ATVs. If you know of any additional websites or sources to look for or buy used ATVs, please post as a comment in this topic.
eBay Motors - usually has a good selection of four wheelers, ATVs, and Side by Sides and offer seller protections
Craigslist - usually has more local ATVs, but be careful as there are no seller protections
ATV Trader - has over 130k ATVs listed by private sellers
ATVSoup.com - new and used ATVs for sale
WantAdDigest - Shows local listings of ATVs for sale
ATV.com - List new and used ATVs for sale
When buying a used ATV, make sure you do your research and find out the book value of the ATV, look over the condition of the ATV, and as for verification of ownership. Be careful who you buy from and get the ATV checked out by a professional dealer or repair shop if you are baying a high price.
Watch our for VIN numbers that are scraped off, this is usually a sign that the ATV was stolen.
Recently Browsing 0 members
No registered users viewing this page.