Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

tgrider

1995 Yamaha Kodiak 400 - Carb Problem

Recommended Posts

I have a Problem. I rebuilt the Carburator on my 1995 Yamaha Kodiak 400. It Starts fine. It Idols fine. I can even putt around in 1st gear. But when I give it throttle and go it will want to die. Sometimes I can drive it and it is fine, BUT most of the time when I go and shift from 1st to 2nd and try to give it gas, it chokes out or looses power and then dies. I thought maybe the fuel line was too long because the gas is gravity feed so I shortened it. Still acts up. Is there an Air/Fuel mixture adjustment on Carb? I know of the screw at the bottom of the carburator but isnt that just idol speed adjustment? Please, Any Suggestions?

Thank You

Share this post


Link to post
Share on other sites


Oxidize_Black. I found a screw on the side but at the bottom of the Carb. There is a small black hose that comes off of it. It just goes down and is not connected to anything. The screw was closed or tighten all the way. When I opened it up fuel started running out. Is that an adjustment? Then there is the larger screw that you can turn with your fingers. That is an adjustment also? Thanks. My Son-In-Law gave me the quad and I have a Snow Plow attachment for it.

Share this post


Link to post
Share on other sites


just the overflow hose, sounds like that's working good :wink:

i think the only other adjustment is the idle as far as i know, but my big bear is 4 years older than yours.

carb diagram.jpg

57d77345639aa_carbdiagram.jpg.90da058b97c366132e06741013c0da26.jpg

Share this post


Link to post
Share on other sites
there is abit of troubleshooting in the manual, section 6 is all carb ...

I figured out a couple of things and it seems that I have fixed the issue. I had an air lock in the fuel line. Fuel was not flowing like it should so I loosened the hose at the On/Off switch and fuel then dumped into the the fuel filter. I also had the Intake vent that goes into the Air Filter box in wrong. It was pointing out the side next to my right leg. While driving I had a tendency to block that intake thus causing it to choke out. That Intake Vent is designed to go in the up position up under the front part of the Seat. There is a hole where that vent fits through. Wow, was that stupid of me. Oh well, its part of being a backyard mechanic.

Thanks

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By dgk_mike
      It will go into neutral, 1st, 2nd, and reverse but nothing after 2nd gear. The shifter moves freely going up completely nothing but when you shift down it works. I’m not sure if it’s tranny issue worth messing with or if I should just buy a new one.  Overall besides that the thing runs like new.

    • By Asen_77
      Hi All,
      My name is Asen and I am from Eastern Europe, Bulgaria. Riding a Yamaha Raptor 700R and this is my first Quad wanted for a vey long time :)

       
    • By StolenATV
      Taken from my car port around 0330 and was taken by at least 2 people found footprints pushing the quad all the way to the road (80 yards)
      The post 2012 Yamaha Grizzly 700 EFI 4×4 Stolen appeared first on STOLEN 911.
      View the full article
    • By mothrottle
      The VIN on my 2018 Kodiak 450 is not where it's supposed to be. I bought this used. Is there another "hidden" location where I can find it? Need the number for insurance co. Thanks in advance.
    • By Admin
      Looking for Yamaha ATV VIN (Vehicle Identification Number) Number Decoders? Once you find your ATV VIN number off the tag on your Yamaha ATV, you can go to all kinds of websites that have VIN Decoders available. The best ones are backed by the Yamaha ATV manufacturer, however there are plenty of aftermarket Yamaha ATV VIN Decoder websites on the web. This topic will stay pinned and if you find any to add, please do it with a reply. 
      The following Yamaha ATV VIN Decoder websites are available where you can just enter your VIN number and it will shows you some of your ATV model details:
      KBB.com https://www.kbb.com/vehicle-history-report/ 
      CARFAX https://www.carfax.com
      autoDNA https://www.autodna.com
      VinAudit http://www.vinaudit.com/
      decodeTHIS https://www.decodethis.com
      VINCario https://vindecoder.eu/
      NICB Theft Check https://www.nicb.org/theft_and_fraud_awareness/vincheck 
       
  • Similar Tagged Content

    • Guest Fox300exchic
      By Guest Fox300exchic
      The Hop-Up: You may be saying to yourself, “that’s a chick bike,” and you’re right. But honestly, it’s so much more than that. It’s one badass bike. http://www.quadmagazine.com/quad/features/article/0,24942,1587044,00.html
    • By dyyjrr9
      I just got a 1991 Yamaha Moto 4 for my son and I am looking for a service repair manual. I know that the timing chain needs replaced.
    • By alexcross324
      Hi all, I try to find this manual in the threads but you have a lot of stock here
      Cannot find this particular manual.
      I found it for YFM200 but not sure if they are the same.
      Thanks if you could help me with that.
      Im new here so if I did something wrong, please tell me.
    • By ej200421
      i was wondering if i could get some help. i been trying to locate where the fuel and air adjustment screws are located on my 95 kodiak 400. i think i found the fuel screw.. i know where the throttle adjuster is but i cant find the air screw. or is there an air adjustment on these carbs?
    • By davidwestfall
      looking for direct shift shifting lever that properly fits my 2003 Yamaha warrior 350 and fits my foot the same as a stock 2003 Yamaha warrior 350 shifting lever fits my foot
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...