Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Ty1997

HELP! How do i set the timing on a suzuki quadmaster 500?

Recommended Posts

I know the piston has to be at TDC, but there is no marks on the cam gear. i kinda figured that when the one bolt is up the cam lobes are down, not touching the rocker arms. i want to know if this is how to do it? someone give me an answer.

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

  • Similar Tagged Content

    • By Alois Specht
      Hi there , have a KAZUMA 500 JAGUAR the rear diff is permanently locked , how can I get it out of lock just about tried everything I think, ?? .  Thank you your help is appreciated.
       
    • By mrfartsalot
      i have a 2001 suzuki quadmaster 500 4x4 that the primary cvt clutch is rusted on any ideas on how to get it off i want to try to reuse it if possible.
    • By Paul Maple
      I have a 1999 Sportsman  500, it was running fine, than started to lose power in the winter, I adjusted the idle screw and away I went, than a few weeks ago it died, I have found that i am flooding the engine, compression was at 70PSI and due to the compression release mech. i assume i am good as it compared to the same PSI on a 2000 sportsman 500 i have. i cannot start the atv unless i go full throttle and it starts an runs for about 30 sec than dies, again it is flooded. i ordered a new carb off ebay as i could get one for around $40. put that in same issue, i have checked the timing, (good), valves out of adjustment i adjusted to .006 still same issue, i have found the exhaust lobe and rocker arm to have some wear, i have ordered new ones, but am looking for any other input in this area as well. would the exhaust cam and rocker arm cause the engine to flood? i have used a bore scope and the piston liner has good cross hatching still? any input would be great.
    • By colin james
      View File 1996-2000 Polaris Sportsman 335/500 Service Manual
      This is the factory service manual for the polaris sportsman 335 & 500.
      You can download the section you need  or download all of the chapters for the complete manual 
      Submitter colin james Submitted 10/19/2018 Category Polaris ATV  
    • By colin james
      This is the factory service manual for the polaris sportsman 335 & 500.
      You can download the section you need  or download all of the chapters for the complete manual 
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...