Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

Recommended Posts

Well I have the old Prairie going again the new cvt belt is installed. What a difference going down hill in 4wd it creeps along no slipping on take off now or climbing hills.

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By technofarmer
      Well its finally happened, its time to replace the belt on my 2011 Polaris Sportsman 500 H.O.   Is there anything specific i need to know before getting into it? Is there one brand of belt i should get over another?   I'm still on my first Polaris and plan to keep it at least another 8 years.   
    • By Sonders
      It appears that the Service Manual thread at top of forum is dead as all the links no longer work.  I'm actually looking for service manual for a 2000 KVF300 Prairie that I just picked up.  Does anybody have link to one that they can share, or know where I can find one?  Thanks in advance for any help.
    • By MarkinAR
      About done with the Kodiak finally. Oldest took it out today and ran the piss out of it, buried it to the belly, and I think its finally about ready to trust. However, there is a clutch slipping that needs to be addressed. It pulls fine from a dead stop to about half throttle. If you go ahead and open it up, the clutch basically lets go at higher RPM. My question then is; centrifugal clutch or main clutch pack bad? I assume since it pulls at low RPM then it's the main clutch pack slipping at WOT. School me though: where does the centrifugal clutch end and main clutch pack begin?  Also added to this issue, he was crusing down a gravel road and all 4 wheels locked up and it died. I assume it tried to throw 2 gears at the same time and locked up. It unlocked though and shifted ok after coming to a stop. 
    • By Jim Waters
      hi everyone. recently iam get a good vibration that comes and goes while iam riding my praire 4x4. iam afraid something is going to detonate. vibration is felt in the steering and then you will here a noise and this comes and goes. its very noticeable when iam on a blacktop surface. iam worried. i cant get any slop in the drive joints i can grab onto. so any input would be appreciated. i have a manual downloaded and i,ve went through it pretty good. my thought is its from the output shaft to the front drive. let me know if anyone has experianced this.
    • By Spartacus Stroppel
      View File 1999-2002 Kawasaki KVF300 Prairie Service Manual
      1999-2002 Kawasaki KVF300 Prairie Service & Repair Manual
      Submitter Spartacus Stroppel Submitted 08/25/2019 Category Kawasaki ATV  
  • Similar Tagged Content

    • By technofarmer
      Well its finally happened, its time to replace the belt on my 2011 Polaris Sportsman 500 H.O.   Is there anything specific i need to know before getting into it? Is there one brand of belt i should get over another?   I'm still on my first Polaris and plan to keep it at least another 8 years.   
    • By Connie Johnson Donald Hudson
      Smells like gas in the oil ... Also, recently replaced belt, new BT does not have grooves on both sides, does that pose a problem?  Also just bought and replaced new carburetor, never has it idled better, but give it gas and it backfires very loudly!
    • By bodatiouskid
      Just bought a 2003 Kodiak 450.At take off,the belt doesnt grab for a few seconds.Is there any wat to tighten belt?& how tight should it be?
    • By toonces
      New to ATVing here and just got a '11 Grizz with the belt drive transmission and I've been suggested to take along an extra CVT belt along in remote rides just in case. I'm somewhat knowledgeable about where to get quality parts for cars but not so much for ATVs. Who makes the best CVT belt for my bike? Also, who makes just ok belts and who should I stay away from?
      Also, I'm looking at getting a snatch block for a synthetic rope winch and wondered if the type rope determines what type of block you should get...or are all snatch blocks the same and I'm just thinking about this one too much?
      Thanks
    • By Tim-ANC
      What is a good after market brand for CVT belts? Want durability and gripping power. Intended for a 2009 Suz King Quad 450.
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...