Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

pjcs92

1994 Suzuki King Quad - Oil Gets Hot

Recommended Posts

my 94 king quad300, the oil lights comes on after riding for an hour or so, the oil is full of 10/40 . light goes out after 10 minutes or so after shut down , any ideas. I love this forum, lots of info and helpful people

Share this post


Link to post
Share on other sites


my 94 king quad300, the oil lights comes on after riding for an hour or so, the oil is full of 10/40 . light goes out after 10 minutes or so after shut down , any ideas. I love this forum, lots of info and helpful people

Are u sure its not a temp light ?

Share this post


Link to post
Share on other sites

My 2002 doesnt have an oil temp light, just a temp light. Id double check that.

Either way, sounds like its overheating. Id check the radiator for dirt &/or debris so its getting good airflow, proper coolant level & make sure the fan is working properly. If all that checks out OK you could have a stuck thermostat bad water pump or some type of blockage of coolant in the syatem. Im no expert but I havent seen just an "oil temp" light on a quad.....but I could be wrong too.

Share this post


Link to post
Share on other sites

it is definitely the oil temp light. I believe the quad is air cooled. gonna try new filter and oil see if that helps . any other suggestions?

Share this post


Link to post
Share on other sites


i would check exactly what Mudflap64 stated ... run a garden hose thru the fins of the rad to clear it out, if it is air cooled, the rad is like a transmission cooler, check the lines going to and from the rad and oil pump and make sure theres enough oil in the crankcase. if the bike is running lean, it will heat up too ...

Share this post


Link to post
Share on other sites

I see, I was assuming its water cooled like mine. I guess an oil temp light on an air cooled makes sense. Id make sure you are getting good air flow around the engine & that none of the cooling fins are plugged up with mud or missing. There should be a fan somewhere on the machine, Im guessing off the crank/ flywheel. Make sure the shrouding around that is clear of debris also. I have also see a plugged up exhaust pipe make air cooled engins run hot, especially if its 2-stroke.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Dwight Williams
      Ok, so I bought this scream of a deal the other day - a 94 King Quad 300 for $40.00.  It's been sitting outside with no carburetor on it for about a year.  Its rusty, missing some parts, wiring is all cut up and spliced etc.  No seat, no racks but the plastic is all there minus the headlight housing.  Anyway, who can pass up a $40.00 quad right?  I get it home and looked at the sight glass for oil level, it's about 1/2 oil and 1/2 water.  I drain it, refill it and turn the motor by hand (recoil starter is missing) and it turns over just fine.  I worked on the wiring for about an hour and got it to turn over with the electric starter and got enough of it sorted out to get a spark.  Did a quick compression test, 70 lbs.  Wet test bumped it up to 90.  Ok, so rings and cylinder washed out with water for a year, not too surprised.  I thought 'what the hell' and sprayed some starting fluid in it and it ran for about 2 seconds - enough to show  it's got life.  Since then the compression has gotten worse, I can't get enough pressure to activate the carb diaphragm, therefore no fuel pump either.  The compression is now around 60.
        Anyway, my question is....is it worth it to try to get this thing going?  I tore the top end down today and the cam and one of the rockers is pretty worn.  I figured a top end job would be about $100 or so, depending on the condition of the cylinder but I'll probably have to put a cam and rockers in it as well.  Doing some research on ebay I figure I'll have to spend about $500-$700 to make the whole machine right again.  Much less just to make it run and use as-is but I won't really like it until it's right.  I don't mind doing the work, I actually enjoy it but I'm concerned about what all that water did to the rest of the internals, I can't really test it all out until I can make it run.
      I know it's a basket case but I'm not into it much at all, even if I do the top end and find something else wrong I'm still not out much.  I'm leaning toward ordering the top end parts and going from there unless you can convince me otherwise - any way to check the rest of the internals without tearing it down?  I plan on flushing the oil cooler before I do another oil change, I've drained it twice now and it gets milky almost immediately just turning the starter - I suspect the oil cooler is polluted badly.
       
      I'll get some pictures today if anyone want to see them.
       
      thanks!
    • By Tiffany Rowland
      I am working on a Honda sportrax I just got my daughter for get birthday and the reverse and neutral light are not working. When I traced the wire down I saw that it wasn't plugged in but I don't see where it is supposed to connect. Does any one have a general idea of where I should look?

    • By dp19
      Hi, I'm a newbie on here.  I just got a 2007 Suzuki KingQuad LT-A450X.  Are there any specific issues to look for on this model?  Any specific maintenance to do other than the usual oil and filter changes?  
      Thanks
    • By Jack Briggs
      Just bought 06 KingQuad 700 and first ride out hit a mud hole, not to deep and it shut off and would not start. 
      Got it home and found the spark plug hole was full of mud and water. Went and bout a new spark plug and began cleaning it out. Put a deep socket in there and it wouldn’t grab. Took a pic with my flash and this is what I see. Any suggestions? And what is it??
       
      previous owner said it had a new coil so that’s why I decided to change out the spark plug, also ordered new coil should be here by the weekend. 


  • Similar Tagged Content

    • Guest
      By Guest
      Ok...I'm gettin' me juevos ready to do an oir filter clean....
      Went to my local harley/quad dealer and he had me purchase the No-Toil kit (Cleaner, Air Filter Oil, Rim Grease)
      What I've read is that the No-Toil cleaner will NOT clean
      other oils off air filters....just the No-Toil oil....
      So, I've also read that others have cleaned their air filters
      in the kitchen sink, used gasoline, or used flash solvent....
      Looking for advice as I've mentioned I'm very mechanically
      DECLINED!
      I'm going to wash the air box seal in the sink and give it a good dry....
      One more thing......No-Toil or Bel-Ray for filter oil?
      Thanks!
      -TD
    • By Mustangiiman01
      I have a 1998 Suzuki king quad that was given to me and was having starting issues  but got that fixed and now the exhaust is getting red hot at the head  was wondering what could cause that. That in advance for any info
    • By wylde1
      I asked my wife if she would pose with one of my quads.. This is the one she picked. Beautiful and a sense of humor..
    • By toonces
      Have a 2011 Grizz 700 and for the diff oil the manual calls for SAE 80 API GL-4 hypoid gear oil. I'll be using Mobil 1 synthetic but as it comes in two different weights I'm not sure which one to get....either the 75W-90 or the 75W-140.
      The 75W-90 is listed as GL-5 and is recommended for use in 'high-performance vehicles like SUVs, vans and light duty trucks.' The 75W-140 weight is also GL-5 and is recommended for 'high-performance vehicles including sport utility vehicles, vans and light-duty trucks.'
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...