Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

richclick2010

2002 Sportsman 500 HO Front Hub Issue

Recommended Posts

New problem.

I wanted to change the fluid in my front hubs only to find that there wasn't any fluid in them but full of grease instead.

Pulled the hub apart and found the hub seals are missing. I ordered Part # 3610019 that was listed for my model. They are too big. They measure 3.258in across and my hubs measure 3.10in. I was baffled. I can only assume that someone in the last 12 years replaced the hubs. They are Polaris hubs though. I have checked through several years and models and all I have seen list the same part number.

Anyone have any ideas on this or happen to know a seal part number with that measurement? The rotor hole is the same as the hub.

This is a 4x4 with Hilliard Clutch.

:aargh:

Thanks for your input.

Share this post


Link to post
Share on other sites


well i know if you have a bearing a certain size and you go to napa, pep boys or a bearing outfit, they really dont care what its for and just go by the measurements, i imagine you can do the same with a seal ...

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

  • Similar Tagged Content

    • By Jean de la Chevrotière
      View File Polaris 700 2002 Owner's manual
      Polaris 2002 700 Owner's Safety and maintenance manual
      Submitter Jean de la Chevrotière Submitted 12/01/2018 Category Polaris ATV  
    • By Jean de la Chevrotière
      Polaris 2002 700 Owner's Safety and maintenance manual
    • By priglmeier
      I own a 2002 Can-Am Quest 650.
      It will start if you massage the throttle a bit and it will continue to run. BUT if you let go of the throttle and try to let it idle it will always die warm or cold.
      It has Non-Oxy premium gas, a new gapped NGK plug, a new carb (as of today) and fresh fluids. After installing the new carb it runs exactly the same.
       
      I only have a few things that I have observed since the new carb:
      The choke still doesn't do anything. It has a good cable and it is hooked up. It on fully off. There is a cable in the top, front of the engine that splits into two connectors. The connected side is in the photo. The other side has the yellow banded section and is not connected. I do not see anything in range of this connector so I don't know if this is normal or not??? The original carb wasn't really dirty or clogged. I'll use it as a spare. I don't see this cable and connectors listed in the Can-Am shop manual. Looking for some help. I want to ride!


    • By gregj49
      Blows out black smoke when you rev it up how do you adjust the carb?
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...