Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

creece

Yamaha Kodiak 450 tail light

Recommended Posts

I have a 2003 kodiak, 450, that the tail, light is being turned on by front brake control handlebar lever which I dont think should even happen . I have disconnected the brake switch by removing the spring. You can barely touch the lever and the tail light comes on the problem is after parking there is enough contact that the light dont burn but it will run the battery down in a period of 24 hours. Its a good machine with right at 5000 miles and 1500 hours but I am at the end of my rope with it

Share this post


Link to post
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Topics

    • By Tiffany Rowland
      I am working on a Honda sportrax I just got my daughter for get birthday and the reverse and neutral light are not working. When I traced the wire down I saw that it wasn't plugged in but I don't see where it is supposed to connect. Does any one have a general idea of where I should look?

    • By Duane Steward
      I purchased a CDI box from Ebay that was listed as the one for a 200trx with round plug.....when I plugged it in the reverse light stays on.....what did I do wrong ? or is it just a bad CDI box?
    • By StolenATV
      Was stolen on Goshen rd Fort Wayne. It’s missing plastic, seat, and lights I was in the process of working on it.
      The post 2003 Yamaha Warrior Stolen appeared first on STOLEN 911.
      View the full article
    • By Karen McDowell
      Went to change oil and get my sons  2000 Suzuki King Quad 300 ready for spring and found the left front wheel wont move at all but the right does. Doesn't matter if it's 2 or 4 wheel drive same issue. Nothing looks bent, tie rod ends and ball joints in place jacked it up and shook wheel and bearing seems tight. Any ideas before I tear the dang thing apart?  Of course my son has no idea what happened.  
  • Similar Tagged Content

    • By Michael Aiken
      Where can I find a wiring diagram for my 2005 450 Kodiak. Thanks.
    • By Kristpj
      I know this tooic has been addressed by many, I’ve looked through many forums and pages. I did not find anything like the problem i have.
      I have a 2007 Kingquad 450. I have a new fully charged battery. When i turn the key, the dash flashes and seems to struggle before getting fully lite. We can hear a small relay near the computer clicking, i think it is the fuel pump relay. When i turn off the engine kill switch and press the starting button relays click and all the power shuts off, i turn the key off, engine kill switch then start over, power is there. Atv will start with pull start, but not elextricly. if i try to use my winch, all power cuts and engine dies. 
       
      Can anyone tell me what it may be? or has anyone fsced an issue like this before?
    • By chuckufarlie
      I have a 2018 Kodiak 450 EPS that just this past Sunday I ran through a bit of water.
      After the puddle the belt was slipping, so I pulled over and drained the ultramatic housing and the slipping problem went away. This was all in L and everything seemed to work fine. Later when I got on a road, I put it in H, but it still rode like it was in low... i.e. I had to rev it up a lot just to get to 30mph.
      When at home I pulled the ultramatic cover off to inspect, and it looked okay in there. Not much dirt, belt and everything are clean, but when I rev up the engine (with cage in place, of course), the belt doesn't get to the top of the clutch (maxes out about an inch or 1.5" from top of clutch, so maybe it is normal).. I put it back together but same thing... H seems like L still.
      Do you think the clutch needs to be further dissected for cleaning, or could this be an issue with the gear selector?
       
    • By Steven Alter
      I have a 2018 450 and the digital gause has started flashing on an off while driving. The backlit also goes on and off. It is worse when I hit the gas. The battery died a few weeks ago and I jumped it but its been fine until last night. Called the dealer and showed them a vid and they recommend replacing the gauge and its like 600 bucks. The machine has less than 100 hours on it. I would really hate to have to change it out. also the unit sometimes has trouble starting. Any ideas?
    • By Admin
      View File 2014 Arctic Cat 450 ATV Service Manual
      2014 Arctic Cat 450 ATV Service Manual
      Submitter Admin Submitted 02/08/2019 Category Arctic Cat ATV  
  • Recently Browsing   0 members

    No registered users viewing this page.


×
×
  • Create New...