Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
these are what i have in my collection ... always looking for more
1985 - 1990 Suzuki LT230 & LT250 Service Manual
1987 - 1998 Suzuki Quad Runner 250 & King Quad 280 Service Manual
1987 - 2006 Suzuki LT80 Service Manual
1987 Suzuki LT500R Quadzilla Service Manual
1988 - 1992 Suzuki LT250R Porting Instruction
1988 - 1992 Suzuki LT250R Quadracer Service Manual
1988 - 1992 Suzuki LT250R Tuning Guide Instruction
1999 - 2004 Suzuki King Quad 300 Service Manual
2002 - 2007 Suzuki 500LTA Service Manual
2002 - 2009 Suzuki LTF250 Ozark Service Manual
2003 Suzuki LTZ400 Service Manual
2006 Suzuki 50LTZ Quad Sport Service Manual
2004 Suzuki 250LTZ Quad Sport Service Manual
2005 Suzuki LTA700 King Quad Service Manual
2007 Suzuki 90LTZ Quad Sport Service Manual
2008 Suzuki 400FLTF King Quad Service Manual
2008 Suzuki 750 King Quad Service Manual
2009 Suzuki 400LTZ Quad Sport Service Manual
ALSO CHECK SUZUKI ATV SERVICE MANUAL DOWNLOADS
By Colby Calk
I recently got a 98 warrior 350 that 'needed the carb adjusted' but the reality is it has no spark. I have a new spark plug, plug wire, ignition coil, battery, and cdi box. I checked continuity and took apart and inspected the starter/kill/light switch on the handle bar, and it all looks brand new and checked out. The key switch seems to be working properly, as when off, nothing works, but when switched on, lights and electric starter button work. It turns over fine, and as I just stated, all the lights work. I took all the plastics off and traced all the wires, and only one had a small cut in it, but it was only through the rubber sheathing, not the wire itself (the blue one coming from the stator). I cleaned some grounds, made sure both relays work, and still nothing. I pulled the stator cover and looked at the stator itself, and it looks great. No broken wires or connectors or anything. Still, no spark. I'm at a loss. Where do I go next? Any help is appreciated.
By Dra O
posted a while back - it was running at one point - I have all the plastic shroud off - it's down to frame and engine now
-fuel pump: when line from petcock is attached, no fuel comes out other side to carb; the line to the carb is open (can blow through it); I thought when I cranked engine that the pump would spit out fuel on other side but it does not; I removed fuel pump and opened it up - diaphragm looks good - but internal areas had lotsa calcification build up - I cleaned this out and dried it good - the clear plastic pieces (?diaphragms) aren't broken - the spring w/ steel ball on end moves freely; am putting it back on tomorrow; but can anyone answer about the pump? isn't it supposed to pump fuel through it... to other side... to carb? puzzling
-along with fuel pump: I replaced petcock 3 weeks ago (gas tank had rusty fuel in bottom - cleaned it out prior to new petcock); when I turn petcock arrow NOT to on or reserve, fuel comes out of line; when I turn it to on or reserve, fuel doesn't come out; puzzling
-I don't know what's on back of fuel pump - it's a valve that has a hose coming out of it - looks like it goes to engine/carb - I haven't traced this out yet - what is it?
-can squirt gas on air filter and engine will run for 2-3 seconds then stop - fuel in top of carb (under diaphragm) does same
-it likely needs carb rebuild - will get to this - but something isn't allowing fuel to get from fuel pump to carb
-I THINK it has a mikuni model x carb - diaphragm is ID 26mm OD 68mm - hard to find inexpensive diaphragm, I guess because it's a model x
-last thing - I replaced solenoid due to old one clicking; I HAVE to be charging the battery or it won't start/turn over - battery just goes dead; but if charging, it'll turn over nicely; i'm guessing it's a bad battery
-any help appreciated - I've never owned an ATV before - inherited this beast from grandparent in-law
Similar Tagged Content
I'm having trouble with the E-ton thunder 90. The electric start has stopped working & for a while the horn would still work but has stopped as well. List of what I've done so far. Made sure the battery was good even tried my battery from my quad tonight & it did nothing I cleaned all plugin connection and put dilect grease on all of them. I pulled the starter and put some juice to it and it works. I pulled the housing apart for the horn and starter button it's good and clean inside. I checked the fuse on the hot wire comming off the battery It has the spline part comming out the side cover for a kick starter so I used vice grips to start it and checked the kill switch button it works and the key switch is working. I don't see any other fuses I can change unless their covered up. I have no owners manual for this quad.
Recently Browsing 0 members
No registered users viewing this page.