Quantcast
Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 11/21/2019 in all areas

  1. Hey fellas...I'm trying to install the rear left axle..there's a bolt running through the end of the axle that goes in the hole where you slide the axle in...I'm having a hard time getting the bolt started on the threads..I was hoping to start it with my fingers and than finish it with an open ended wrench...its very hard to do because it's such a tight spot..has anyone ever done this job before ? Any help would really be appreciated..thanks Ed
    1 point
  2. Hi, I got a check engine light and a diagnostic code 520194 2 and i know it has something to do with throttle voltage out of range I'd like to know if thats something that can be adjusted ? Or does anybody know what should i test ? I just bought this atv and I'm fixing it as its been in an accident. I also changed throttle leaver as original one was broken and I noticed inside the 4x4 selector assembly there are 2 contacts but I'm not sure if they're suppose to make contact at idle. I found some info online but some are saying they're suppose to touch and some say they're not. I think id depends of the year of the machine but I'm not sure. I'd really appreciate any help that i can get with this Thanks
    1 point
  3. I’d imaging you could ream out the holes to make it work. As long as it’s not on the edge and your bolts are torqued. You’d be fine. Sent from my iPhone using Tapatalk
    1 point
This leaderboard is set to New York/GMT-04:00


×
×
  • Create New...