Quantcast
Jump to content

JAK1985

Members
  • Posts

    11
  • Joined

  • Last visited

Posts posted by JAK1985

  1. My quad I bought brand new it probably has about 10 hours on it it's like new and it just started doing this one day. I did the same thing brought it to the dealer they cleaned the carb did not work they wanted to check the valves but I wouldn't let them, I know it's nothing to do with the motor or the carb. If I were you I would hold out on the new carb, they are very expensive. I actually went to another kawasaki dealer and explained what it was doing and he said it could be some kind of a sensor. But I haven't tried it, just tired of wasting my money and nothing working. But if you figure anything out please let me know.

  2. Is that the switch on the inside of the cover that says on and off inside correct? Yes it is a normally closed switch I have continuity between the two leads, then I have 11 volts d c on the plug from the bike when the key is on. The dealer said it is a sensor that is telling the quad that the belt is worn or no good, and it is cutting the quad out. Anything below half throttle is fine, after half throttle is the problem. The dealer said it is one of two sensors but they also said its crazy to change both of them because they are very expensive. I have a video of what it's doing but I am new to these forums and don't know how to post it, if someone can walk me through posting it I would appreciate it or I can email it to you.

  3. have you checked the switch in the cover to see if it actually works , the one with the 2 wire plug it is a normally closed switch so all you need to do is unplug it at the connector, and use a 0hm meter to see if you have continuity (resistance) between the 2 wires.

    a video from youtube about resetting the belt ...

    I have not done that yet. So if I have continuity between the two leads the switch is good, and if I don't have continuity is the switch bad? Do you check it with the key on or off? Thanks

  4. I have a 09 prairie 360 it's like brand new I only use it for work around the house and plowing. I drain the carb after every time I ride it, it's not a carb issue. When I go full throttle it feels like a rev limiter is kicking in, just like when I go in reverse without the override. I asked the dealer and they told me it to do a belt reset and check the belt. I did the belt reset and the belt is fine. At one point it went away for a couple of months and then it came back. The dealer said it might some kind of a sensor for the belt. Any ideas

×
×
  • Create New...