Search the Community
Showing results for tags ' bigbear'.
-
my big bear is having starting problems. i have replaced the starter, solenoid, and battery. the electric start turns the starter motor but i still have to pull the pull start once to get it started while hitting the electric start like the starter motor isnt turning fast enough. could it be a faulty solenoid? maybe not pushing enough power to the starter motor? if so how much power should be coming out of the solenoid if i was to put a meter on it? any suggestions, ideas?
-
I cant find help anywhere so Hope this is the place, I traded for a 98 350 bigbear 4x4, has no brakes at all, so I have back brake assembly apart and I think it just needed cleaning and adjustment, theres a thing I guess its called the camshaft that lifts shoes up against drum. it needs adjusting, in back it has this arrow, should the can lay horizontial front to rear or is there a certain position, any help would be great:
-
What's up I just picked up a 98 bigbear I'm lookin to build a snorkel and try to make it as water proof as possible.. That being said I'm just curios if anyone has one that's done this or tryed this before.. Just trying to find out if anyone knows where all the breathers are like crank and maybe diffs.. If someone could help me out that'd be great just trying to hit some deep holes with out filling my motor.. Thanks alot
-
My ATV only starts when in full choke even after I let it warm up and ride around I try to lower the choke but will end up stalling. I just put seafoam in the gas tank and will try that out first in about 15 min. I'm just worried that when it gets cold I'll have issues. Also, when I try to lower the choke after being warmed up I hear no difference in the idle. Is there a way to adjust this? Side question, when I do stall and im in gear its hard to go back into neutral to start it up again. I tried rocking back and forth but that didnt work. After 3 min it went into neutral smoothly.
-
my big bear has a problem shifting. it goes into first fine but sometime i have to try to shift a couple times to get it in 2nd and 3rd gear. could the clutches be bad what all could it be? Thanks
-
:huh:i need to split the right side of the case according to the yamaha dealership to make sure i have no dirt or anything in the engine before i put my cylinder back on since i got it bored over. do i have to worry about anything just falling out it i just pull it off. someone told me to get a pressure washer and soap and spray the hell out of it and itll take any dirt or anything out. will it hurt anything or what is your ideas on the subject thank yall.