Search the Community
Showing results for tags ' lta400f'.
-
Ok on top of my brake issue I am also having a low voltage issue. The atv runs great it's just the lights/fan do not work and the battery does not charge. (Have to start with recoil start). I tested the wires that are coming from the stator for the charging part (3 black wires) and they all range from 1.3 volts to 1.8 volts it gets higher as the engine goes slower and the lights get brighter as you are killing the engine. Now when I idle it a little higher it stays steady at 1.18 volts. What is going on here is the stator bad or what else can I do for diagnosis. Thanks
-
Ok I have replaced the rear brake shoes on my Eiger and still have the same problem with them just not working. I have tried everything I have even loosened both adjustment nuts on the swing arm by the drum as far out as possible and then turned the shaft for the brakes so they would start pushed out a little and then put the swing arm on and am still having a problem with them just not working. I will tighten the adjustment bolt all the way back in after putting the swing arm on the shaft and squeezing the brake lever moves the shoes but they for some reason don't touch the drum. I bought a new set and both have the exact same amount of pad on them. So my question is is there anything I should be looking for or doing or if someone has pics they could post of their setup I would greatly appreciate it. Thanks Mike