Search the Community
Showing results for tags ' missing'.
-
Just bought this quad and it is in pretty good shape. It is missing a small plastic piece right above the headlamp cover right in front of handle bars. Does anybody know where I can find this piece? Now the CV axle. The left inner CV boot is ripped and wheel hesitates when making a sharp turn in that direction. I am trying to find a replacement or a fix, but have been recieving different suggestions for the fix. First one was buy a replacement CV axle. Second said to that the inner was it's own build and that if you ought a CV axle it would only e a half shaft. Just confused and need some guidence. Thank you guys!
-
New member here and looking for help. At 200 hours the check belt light came on. Removed the converter cover checked the belt and followed instructions for the reset. Now I have a miss that starts at 35 mph and it won't go past 50. It acts like you are turning the key off and back on. Pretty well ruled out carburation and fuel flow. When I had the cover off I started the machine and noticed later a warning not to do that.
-
2000 Bayou misses out about half the time. I have done the following Cleaned the Carburetor. Replaced the plug and check the plug wire, its wire, Checked the plug boot it ohms out at 500 ohms Motor has 125# compression. I did find a barked place on the pickup coil wiring coming out of the motor case. I pulled the cover and ohm the pickup coil. It ohms at 470 ohms. I repaired the barked insulation and reinstalled. I replaced the igniter with a new one. I was told that the voltage regulator could be the problem so I unplugged it and made made sure the battery was fully charged and started it and ran it off the battery only. Still misses out. I added a jumper wire to ground on the igniter to make sure there was not a bad ground somewhere. I also added a hot wire to the igniter to be assured that the key or kill switch was not the problem. Nothing I have done has corrected the problem. Attached is a video. Note: the video camera does not show what the human eye sees. The timing light does not light when it misses but the human eye sees that it is dim during the times the video shows it not flashing. [ame]https://www.youtube.com/watch?v=QlSE7bIhWI8&list=HL1396568821[/ame] Any Help any of you guys or gals can give me will be appreciated. Thanks
-
I have had problems with my artic cat 2004 400 4x4 manual transmission. It started with me having not riden in a month and when i started to ride gas came out of the overflow and a miss was going on. Cleaned carb and adjusted float and stoped the leak but miss was still there. Started leaking again 1 week later and went back in carb and found black rubber due to fuel line coming apart. Cleaned and reassembled. No more leak and cranks and idles fine but when riding still has small miss that you can hear sometimes poping back through carb. I have adjusted float, adjusted pilot screw, checked valve adjustment changed spark plug changed fuel line all seems fine. Could this be electrical??? When given almost full throttle out of gear it will miss bad is this due to a rev limitor or does this modle have one???? This is driving me nuts. Any advice will be helpful Thanks.
-
This is my first post and I have some pics which I have attached. I have just bought a doer upper, Big Bear 1995 350 fwd. My first ever quad !! I took off the odometer cable and housing from the crankcase and there was no drive gear on the end of the cable. No sign of it in the part of the crankcase I could see. I am concerned the drive gear could have fallen down into the crankcase. Can I just take off the crankcase cover while the engine is in place to check if the cog has fallen into anything it could damage when I next start it up.
-
Hello,i have a 2002 Eiger that i bought new,i have only put 900 miles on it,it stays in my garage most of the time,last oct. it started out the engine would die till it got warmed up,now it misses and pops i dont know it its a backfire or not,but it seems to do it most when im in 1st gear,when i shift to 2nd and up it runs great,it more in higher rpm,it did sit up for about 3 months before it started doing this,does anyone have any anwsers for this?Thanks
-
Wonder if anyone can help me out. My buddy had an 07 Sportsman 500 EFI that is missing really bad. It's so bad that it almost throws you over the handle bars when you try to ride it. We all got gas from the same place so thats out and we pulled out the spark plug and it was really clean. The only changes that have been made are a radiator relocation kit and shorkel kit. We thought maybe it was getting to much air but we covered the shorkel intake and still the same thing. Any ideas?? Thanks