Search the Community
Showing results for tags 'ltf250'.
-
Hello all, I just got and old and in pretty bad shape Suzuki 1985 lt250ef or eef ?? would like to get a free manual or info on how to try to get it started or at least see if it will start.... Any help would be appreciated. Thanks Mike
-
View File 2002 Suzuki LT-F250K2 QuadRunner Service Manual 2002 Suzuki LT-F250K2 QuadRunner Service Manual Submitter Ajmboy Submitted 11/10/2021 Category Suzuki ATV
-
-
1988 suzuki quadrunner 250cc 2x4 (LT-F250) not starting
mmmPUDDIN posted a topic in Suzuki ATV Forum
I've had this machine for 2ish years, has ran great up until winter. Sometime during then, I managed to break the exhaust right before the muffler. The summer before it had a hard time idling, but we fixed it by cleaning the carb, and messing with idle. Near the end of last year, the only way for it to fire was the have full choke, and full throttle, and the engine bogged down and you had to keep on throttle for 25mins. Over winter, the throttle had dislocated, and I got it back in place. We got it running, and all was good. Spring came along, and now it doesn't start at all. A fluid is coming out of the exhaust, and I'm told it could be water from over winter. I checked the airbox, and the air filter isn't for this quad, it also is barely sucking air. There appears to be little to no compression, based on this. I'm pretty sure the engine is flooded, as the spark plug produces a spark, but is oxidized. I don't know how the previous owner treated it, or when it's last oil change was. A bolt on the engine has either oil or gas seeping through it,abd was loose. I tightened it and it consisted. The engine is basically positioned in the rear, and it needs a good clean, I don't have a pressure washer, so I can get the built on dirt off. any recommendations on how to get the beast started again? -
I need to get a rear axle for this machine. Are 2wd and 4wd the same axle? Are left and right the same axle? What years will fit a 1990? Thanks
-
I just got this quad a few days ago and finally got it running. It has oil leaking and it seems to be coming out around a cylinder bolt. Not the valve cover but just below and to the rear. Is there supposed to be crush washers on that bolt? and what are those bolts supposed to be torqued at? Thanks