Search the Community
Showing results for tags 'magnum 425'.
-
Anyone have it on PDF they can send? Sent from my SM-F926U using Tapatalk
-
I chased down the leak on my 97 Magnum 425. I have a nice leak coming from the water pump weep hole. I am being told the oil seal inside the pump needs to be replaced. Can anyone tell me what is involved in the repair. Can it be done without pulling the motor? Thank you! Sent from my SM-F926U using Tapatalk
-
Neighbor gave me this quad that's been sitting outside in the east Wyoming snow and rain for at least 5 years, maybe longer. Looking to share my revival discoveries with others and hopefully learn from what others have already done on here.
-
Will not start with out a shot of ether then only runs until it's burnt! Replaced fuel pump, carb, fuel filter, fuel shut off, new plug! I'm lost now! Could it have a bad coil? prior to this it would start and run fine!
-
Ran find shut down the quad next day would start and idle when you try to accelerate it would start popping through the carb got a rebuild kit soaked it in chem clean after break down for 12 hours on slow vibrate reassembled and adjusted per manual still the same thing any help would be really appreciated thanks and happy ridding
-
Greetings I have a 98 Polaris Magnum 425. Runs GREAT for 10 minutes then starts to load up (sounds rich) and looses power. Final;ly just stalls out on idle. If it sits 20 minutes will run again. replaced fuel, added fuel treatment (seafoam), Replaced plug (carbon fouled), plug wires, air and fuel filter, checked all fuel and vac hoses, REPLACED carb with new. Still no good. Just ordered a coil, not sure if that will help Note: both the new and old carb only had the idel adjuster screw - cant find the jet adjustments or air/fuel mix screws so I cannot say how they are set. Looking for ideas short of spending big $$ on Polaris service HELP????? Thanks Dan